armature的例句大全

The result shows that armature reaction reactance can be calculated by traditional electrical machine design method; leakage reactance of semicircular slot can be determined by round-shape slot and rectangle slot leakage reactance; and FEM is more suitable for end region leakage reactance calculation.

结果表明Powerformer的电枢反应电抗可以采用传统电机设计方法计算，半圆形槽漏抗可以根据传统圆形槽和矩形槽漏抗的计算方法来确定，端部漏抗适宜采用有限元方法计算。

The main parameters formula of the six-phase disc permanent magnet synchronous motor is also put forward, such as armature reactance and slot leak reactance. The corresponding finite element method of these parameters also been introduced. the two results are basically the same.

推导了六相盘式永磁同步电动机的电枢反应电抗、漏抗等的计算公式，同时也给出了这些参数相应的有限元计算方法，两种计算结果基本一致。

Eddy-current loss in armature winding of slotless motor

无槽电机电枢绕组中的涡流损耗

DC Motor Slotless Armature Winding Design Procedure

直流电机无槽电枢绕组设计方法分析

Due to larger equivalent air-gap and flux leakage of slotless permanent magnet linear synchronous motor ( PMLSM), magnetizing current method was adopted to obtain equivalent current density of permanent magnet, however armature current was considered in practice.

建立无槽式永磁直线同步电动机分层解析模型，由于电机等效气隙较长、漏磁较大，采用磁化电流法等效永磁体电流密度，电枢电流按实际情况考虑。

Introduced the repair-experience of the AC driver of the electrostatic printer and proposed the method to improve the primary circuit with the solid-state armature.

介绍静电复印机AC驱动器的维修经验并提出用固态继电器对原电路进行改进的方法。

NEW METHODS OF LEAKAGE REACTANCE MEASUREMENT OF ARMATURE WINDING FOR SYNCHRONOUS MACHINES Identification of Leakage Reactance for Asynchronous Motor

同步电机电枢漏抗的测定新方法异步电动机漏抗参数的辨识

Analyses the formation and essence of iron loss on electrical machine, discusses the demagnetization principle of armature reaction of direct current machine, specifies the implication of parallel operation of synchronization generator by quasi-synchronous method, thereby understands relative concepts deeply.

分析了电机中铁心损耗的形成机理及其本质，讨论了直流电机电枢反应的去磁机理，明确了同步发电机准同期并列的含义，从而深刻理解有关基本概念。

In the end, the waveform and value of electrical potential of winding and armature reaction property curve are gained through electromagnet field calculation, and compare it with the calculation result.

最后，对谐波励磁同步发电机的负载运行进行了计算，得到了基波绕组和谐波绕组的电压大小和波形以及电枢反应特性曲线。

Semi-Analytical Approach for Armature Reaction Field of Surface Mounted Permanent Magnet Brushless Motors

表面式永磁无刷电机电枢反应磁场半解析法

The armature reaction of the sample motor is also discussed in this dissertation.

以样机为主要研究对象，对切向磁化结构永磁无刷直流电机的电枢反应情况进行了实测、分析和总结。

A new solution of anti-magnetized magnetomotive of quadrature axis component of armature reaction in permanent magnet motor

永磁磁极电机横轴电枢反应去磁磁势新解法

In this paper, the feature of armature reaction for PM synchronous motor is analyzed. The coupling between direct-axis and quadrature-axis magnetic paths and the concept of coupling reactance are explained in detail.

本文详细地分析了永磁同步电动机电枢反应的特点，说明了直交轴磁路间的耦合以及耦合电抗的概念。

Analysis of Armature Reaction Magnet Potential Influence with the Optimum Commutation of Brushless DC Motor

永磁无刷电机电枢反应磁势对最佳换向位置的影响分析

Analytical prediction of the armature reaction and winding inductances of permanent magnet brushless DC motor with concentrated coils

集中绕组永磁无刷直流电机电枢反应及绕组电感的解析计算

A capacitor ( 123) is electrically connected with diodes ( 124,125) and field winding ( 122) of field magnet and armature.

电容器（123）电气联接到二极管（124125）以及场磁体和转子的场线圈（122）。

The armature is the collection of conductors that will spin to crank the engine.

电枢由线圈组成用以使发动机曲轴转动。

For designing a digital control-rod position detector and calculating its output binary code easily, the coding mechanism of a coil-coding control-rod position detector has coding factors for the secondary coil arrangement, the coil connections in a group and the magnetic armature position.

为了设计数字式控制棒位置探测器，根据线圈编码棒位探测器编码机理，确定了探测器的3个编码要素，即测量线圈的布置方式、线圈的分组接线方式和衔铁运行位置。

Considering the nonlinear brought by armature reaction of the DC motor speed control system, a state feedback linear method is used. The speed_loop slide model variable structure controller is designed by constructing the switch function of speed error.

针对具有电枢反应非线性的直流电机速度控制系统，应用状态反馈线性化方法对其进行线性化处理，并利用速度误差构造切换函数，设计了速度环滑模变结构控制器。

New Processing Technics of Motor Narrow-yoke Armature Core

电机窄轭电枢铁心加工新工艺