bending strain的例句大全

The pivotal dynamic indexes such as tip error, joint torque and bending strain previous works.

分析计算了机械臂末端误差 、 关节扭矩、弯曲应变等主要的动力学指标.

The methods of compressing strain energy and bending strain energy are adopted to study low temperature performance of montmorillonite modified asphalt with two different montmorillonites by indoo.

通过两种武汉市售蒙脱土和实验室纯化蒙脱土，采用压缩应变能、弯曲应变能的方法，进行蒙脱土改性沥青低温性能研究。

And the influence of bending strain on critical currents and measured losses were analyzed.

分析了弯曲应变对它们的影响。

Beam bending test of RPM pipe and control of beam bending strain in construction

RPM管梁弯曲试验及其梁弯曲应变的工程控制

Determination of the long-term ultimate bending strain and calculation of the long-term ultimate relative ring deflection, both under wet conditions

潮湿条件下长期环状弯曲应变和长期环形偏转的极限测定

Series solutions were derived for the in-plane strain, deflection and bending strain that satisfy the simplified boundary conditions to calculate the shear lag coefficient.

根据简化的边界条件，得到了面内应变和弯曲应变的级数解，进而求得剪力滞后系数。

The FA reducer pin teeth structure is lying pillow type, so the bending strain may be ignored.

由于FA型减速器针齿采用卧枕式结构，弯曲变形可不计。

Measurement and Analysis of Dynamic Bending Strain in Marine Shafting

船舶轴系动态弯曲应变的测量与分析

This thesis establishes the mathematical models of measuring angle strain and bending strain, develops the functional relation between the strain and the measuring values.

建立了电磁检测法检测构件弯曲正应变和剪应变的数学模型，推导出应变与时间域计测值之间的函数关系；

In this paper, some data are calculated, such as strength, stiffness, bending moment, torque and so on. Distributional feature of stress and strain was analyzed: the dynamic characteristic of the bus frame had been researched with modal analysis technique.

计算出客车在各种工况下的强度、刚度以及弯矩、扭矩等，分析了应力、应变分布特点，并且使用模态分析技术研究了车身结构动态特性。

Study on strain concentration area for SB type bending beam sensor

SB型弯曲梁式传感器应变集中区探究

In the NC bending process of thin-walled tube with small bending radius, the maximal hoop strain can reach 1/ 3 of the tangential strain and can not be neglected.

薄壁管小弯曲半径数控弯曲成形中，周向应变不可忽略，其值最大可达最大切向应变的1/3；

The results made clear that the widely used method with attached stiffness set in compressive test of stress-strain complete curve was not proper for concrete in direct tension. complete curve of a three-point bending concrete beam is realized.

在普通试验机上进行的混凝土抗拉应力-应变全曲线的试验研究结果表明，在抗压全曲线试验中采用的刚性试验机和附加刚性组件的方法在抗拉全曲线的试验中并不适用。

? This paper studied the relationships between uniaxial tensile and compressive stress strain and the bending strength with 50% of cement replaced by micro slag.

本文采用美国产MTS试验机，研究了掺50%微矿粉混凝土的轴拉应力应变关系、轴压应力应变关系和抗弯强度。

among all the studies, the elastic constants measured by electrical strain gages and three-point bending experiment;

其中，材料弹性常数的测定采用电测法和三点弯曲法；

among all the studies, the elastic constants measured by electrical strain gages and three-point bending experiment;

其中，材料弹性常数的测定采用电测法和三点弯曲法；

Experimental study on limit tensile strain under bending of compacted soil

几种击实土挠曲极限拉应变的试验研究

bending stress-strain relationship of high alumina bricks at elevated temperatures

高铝砖高温弯曲应力-应变关系

analysis on the strain distribution of carbon fiber in coherent length of member in bending

受弯构件粘结长度内碳纤维应变分布的分析

Effects of temperature and loading rate on the flexural-tensile strength, strain and stiffness modulus of ATB-25 asphalt mixture were discussed using three-point bending test.

通过沥青稳定碎石基层ATB-25沥青混合料的三点弯曲试验，研究了温度及加载速率对弯拉强度、弯拉应变及弯曲劲度模量的影响规律。