contact paper的例句大全

This paper describes main failure mechanism for MOS VLSI, Thin oxide breakdown, hot carrier effect, Al-Si contact failure, electromigration and soft errors. It gives out some technical measures to prevent above-mentioned failures.

本文论述了MOS VLSI主要失效机理，即薄氧化层击穿、热载流子效应、铝－硅接触失效、电迁移以及软错误，并给出了预防上述失效的一些技术措施。

This paper studied the influence of the different conductor material such as AU| Pd-Au, the different film thickness. 125 ℃. 300 ℃ thermal aging and temperature cycle on bond strength with two methods of destructive wire bond pull test and bond contact resistance test.

本文使用焊点破坏性拉力试验和焊点的接触电阻测试两种方法，研究了导体材料（Au、Pd&Au）、膜层厚度、125℃、300℃热老练和温度循环对焊点键合强度的影响。

Sherri wrote a letter to a local paper asking her mother to contact her.

谢瑞给当地的报纸写了一封信，让妈妈与她联系。

Modeling of cam mechanism in internal combustion engines is discussed in this paper. As an example, FB2 cam is used to describe the modeling processes of geometry design, contact stress and wear calculation. And the modeling technology has been provided.

作者探讨了凸轮机构摩擦学设计中的仿真建模问题，并以FB2凸轮为例描述了几何设计建模、接触应力建模、磨损计算建模过程。

This paper introduces a type of oil reservoir different from conventional reservoirs. It has no uniform oil-water contact and is an oil-in-water special lithology reservoir hold in a large aquifer and presenting as thin lens or flaser shape.

文中所介绍的这种油藏与常规油藏不同，它没有统一的油水界面，为呈薄的透镜状或条带状夹持在大段水层中的非常规的水包油特殊岩性油藏。

This paper describes a method in which the whole process of the contact fatigue crack propagation can be detected from the crack incubation to the spalling.

本文叙述了一种能检测从裂纹萌生到剥落全过程的接触疲劳裂纹扩展的方法，建立了接触疲劳裂纹扩展曲线&裂纹长度A和循环次数N之间的关系。

A composite process composed of complex extraction, Fe/ C reduction, neutralizing sedimentation, anaerobic hydrolysis, contact oxidation and filtration was adopted to treat niclosamide wastewater. The process scheme, operation parameters and performance are presented in this paper.

论述了络合萃取-铁碳还原-中和沉淀-厌氧水解-接触氧化-过滤工艺处理氯硝柳胺生产废水的工艺流程、工艺参数和处理效果。

In this paper, an electric device is proposed to measure contact stress on the sealing surface of sealing elements.

介绍了西北工业大学研制的密封面接触应力的电测装置。

This paper studies deviation of old method to forecast oil ( gas)-water contact. This method is corrected as formation water saturation.

文章在充分研究了原有压力法计算油（气）水界面海拔公式中存在的缺陷后，指出应引入含水饱和度参数对公式进行修正。

In this paper, a temperature stress integral formula for the linings and surrounding rock of hydraulic pressure tunnels has been developed accurately by the elastic-contact theory on the basis of mechanics of elasticity.

本文还应用弹性力学中的弹性接触理论，严密地导得了水工有压隧洞衬砌和围岩的温度应力积分表达式。

In this paper, three-dimensional finite element models are set up for structures with different consolidated bases with ANSYS software. Contact elements are created at the contact surface between the soil and foundation. The dynamic behavior and Seismic nonlinear responses of the differently based buildings are analyzed.

运用大型有限元分析软件ANSYS对基础嵌固条件不同的结构建立三维有限元模型，在土与基础的接触面建立接触单元，对比分析结构在不同基础固结条件的动力特性以及非线性地震反应。

In this paper, a scheme on the contact line zigzag data ′ s defects of small radial curves in dynamic measurements was put forward.

通过对动态测试接触网接触压力缺陷的分析，提出了解决方案。

In this paper, the temperature difference induced by thermal contact resistance between two semi-infinite long cylinders at low temperature and vacuum has been studied theoretically, in the meantime, some useful calculation expressions are presented.

针对低温真空条件下，半无限长圆柱间的接触热阻温差进行了理论分析，并得到了一些有用的近似计算公式；

This paper first puts forward the concepts of total connect map and contact surface, and then proposes a map complexity measure based on the concept of contact surface.

本文首先提出了全连通地图的概念，而后给出了接触面的定义，提出了基于接触面的地图复杂性度量方法。

This paper analyses the contact stress between the rollers and the outer track of roller bearing in detail, and then concludes the contact stress of all kinds of the bearing rollers.

本文就三牙轮钻头滚动轴承滚子与外圈之间的接触应力进行了详细的分析，得出各种类型轴承滚子的接触应力分析情况。

Finally, change mind of family education in the rural areas, teach parents grasp the method that nurturing and training children, establish long-term mechanism contact with school. This paper aims to afford reference and experience for government decision-making departments based on the above suggestions.

最后，更新农村家庭教育观念，让家长掌握教养子女的方法，建立长期与学校的联系机制，基于以上提出的对策，为政府决策部门提供参考借鉴之意。

Then the paper make use of scanning microwave microscope, do some impedance test on contact spot to analyze how these factors influence the impedance of them from a microcosmic angle.

借助于扫描微波电镜，对腐蚀触点进行阻抗测试，分析这些因素是如何影响触点的接触阻抗。

The tooth flanks contact strength of CATT gear is decided to a targe extent by its tooth flanks contact zone and contact stress. The paper mainly analy-ses the tooth flanks contact zone and contact stress as well as the geometric influ-ence of the gear on them.

CATT齿轮的齿面接触强度在很大程度上取决于其齿面接触区和接触应力。本文主要对该齿轮的齿面接触区和接触应力及其主要几何因素的影响进行了分析。

Dandy roll: A cylinder of wire gauze in the paper making machine that comes into contact with the paper while it is still wet. The dandy impresses the watermark and the laid lines into its surface when required.

水印辘：在造成纸机上的金属纲圆筒，它卢湿纸接触，按照需求压上水印水纹。亦称面辘。

The acute toxicity of heavy metal Cd and Cu to earthworms ( Eisenia andrei) was studied by the methods of both contact filter paper test and artificial soil test.

采用滤纸接触法和人工土壤法，研究重金属镉（Cd）、铜（Cu）对安德爱胜蚓（Eisenia andrei）的急性毒性。