crank angle的例句大全

The paper introduces the designs of best transmission angle of crank sliding block mechanism for candy packaging machine controled by computer.

介绍了一种四杆机构设计方法，据此设计的四杆机构能够满足最佳传动角条件并保证预期机构类型。

The paper presents the algorithm for the minimal work flow transmission angle γ gmin by the means of the motional analysis of crank sliding block mechanism.

通过对曲柄滑块机构的运动分析，得出了最小工作行程传动角γgmin的求法。

When the crank rotates at the speed of 20 rad/ s, mechanisms are in an unstable state, at an angle of about 300 °, the actual clearances are below the radium of clearances, pairs lose contact, which results in collision between them;

当曲柄以低速20rad/s转动时，系统处于极不稳定的震荡状态，在转至300°左右时，运动副间隙小于半径间隙，脱离接触，发生明显的分离碰撞现象。

Introduce calculation of phase angle for response of foundation power under action of simple harmonic perturbation force of crank piston type compressor, especially discuss phase angle calculation of level rotation power response by using vibration resolution method in detail.

对活塞压缩机基础在简谐扰力作用下的动力响应相位角的计算，特别是运用振型分解法对水平&回转振动动力响应相位角的计算进行了详细的讨论。

By keeping some special relationships among some link lengths, we can obtain a long dwell of its oscillating output member at some limit position. The corresponding rotating angle ( the angle of repose) of the input crank may exceed 200 °.

利用该机构中某些构件长度的特殊关系，使作往复运动的从动件能在某极限位置上有很长的停歇时间，相当于主动件的转角可达200°以上。

position analysis of minimum transmission angle of idle stroke in crank-rocker mechanism

曲柄摇杆机构慢行程最小传动角位置分析

based on the review of the existing silk looms in our country, the reconstruction of rollingup mechanism, back beam height, machine depth, angle disc of crank shaft, and right or left type of the machine is discussed.

本文在介绍我国现有丝织机的基础上，对丝织机改造中有关卷取机构、胸后梁高低、机身长短、曲轴回转角度盘和左右手机型等问题进行了讨论。

upright installed spherical crank-rocker mechanism designed by the use of auxiliary angle method

用辅助角法设计正置式球面曲柄摇杆机构

improved auxiliary angle method of designing upright -put crank-rocker mechanism according to allowable transmission angle

改进的按许用传动角设计正置式曲柄摇杆机构的辅助角法

study on the performance and design diagram atlas of planar crank and slider mechanisms based on auxiliary angle method

关于平面曲柄滑块机构辅助角方法之性能与设计线图丛的研究