critical load的例句大全

Furthermore , the larger diameter of case rear aperture is, the greater critical buckling load is.

壳体后开口直径越大, 临界屈曲载荷越大.

The critical buckling load is influenced by the pattern of bottom-hole assembly directly.

下部钻具组合的具体方式将直接影响其所能承受临界失稳载荷的大小.

The results showed that the critical fracture load of passive films reduced and the displacement excursion decreased with increasing the concentration of hydrogen. The reduction of radial breaking stress and elastic modulus of passive films is attributed to that hydrogen changes the structure of passive films.

结果表明：随氢含量的增加，不锈钢钝化膜的临界破裂载荷降低，位移偏移量减小，氢导致钝化膜的径向抗拉强度（应力）和弹性模量降低，钝化膜随氢含量的增加而逐渐软化。

The Introduction Dead Load Test of Base Pile ON THE EXPANSION OF CRITICAL VALUE OF CARRYING CAPACITY

基桩静载试验论载畜量阈值拓展

The calculation method of flight safety time margin is given when critical parameter respectively is load and height.

给出了临界参数分别为过载和高度时，飞行安全时间裕度的计算方法。

The point at which branching of the graph occurs is called a bifurcation point and corresponds to a critical value of the load.

图上发生分叉处的点叫分支点，它相当于荷载的临界值。

Another critical factor when designing tricycle gear is to properly balance the load carried by the main gear versus the nosewheel.

前三点起落架的另一个不利因素，设计时需要较精确的分配主轮与前轮的负荷。

Closed-loop soft water cooling system shall be controlled fully automatically and necessary consideration shall be taken on such critical aspects as anticorrosion measures, water quality, control on water temperature difference ( At) and hot load ( Q) to assure normal operation of the system.

软水密闭循环冷却系统应实现全自动控制，考虑必要的防腐措施、水质问题，水温差（Δt）和热负荷（Q）参数的控制等关键因素，以保证系统的正常运行。

When the sliding velocity or load exceeds a certain critical value, the wear volumes of the two nitrided layers increase with increasing the sliding velocity or load.

当超过一定的滑动速度或载荷时，两种渗氮层的体积磨损量随载荷或滑动速度的增加而迅速增加。

The experimental study on physical parameters of gingko is conducted. The structural size, compressive crushing load, critical compression and density of gingko core are measured. The tests showed that the gingko core could be classified into 4 grades by step of 1 mm.

对银杏核的结构尺寸、压缩破坏载荷及临界压缩变形量、密度等物性参数的测定表明：银杏核分级时以级差1mm、分级数以4级为宜；

the critical anchorage length and ultimate load functions are derived in response to the average bond stress.

基于所得平均粘结强度，推导了临界锚固长度和极限荷载表达式。

Considering the tangential force applied on a contact spot, the critical area demarcating the elastic and plastic regimes is obtained by comparing the normal elastic load with the normal plastic load.

计及作用于接触斑点上的切向力，通过比较作用于接触斑点上的法向弹性载荷与法向塑性载荷，确定了区分弹性接触与塑性接触区域的临界接触斑点面积。

changes in geotechnical properties of silt and its critical erosion threshold in yellow river estuary: influence of vibrating load

振动导致黄河口粉质土性质与起动流速的变化

When the load amplitude is above a critical value, the bucket settles obviously during loading.

当载荷幅值超过一定值时,在激振过程中桶产生了明显的沉降, 桶的沉降较远处土体明显地快.

Moreover, the load impedance step is dynamic, and the points computed by the method are possibly distributed over two sides of the critical points on PVZ curves.

同时，该方法求得的负荷阻抗步进量具有动态变化特性，并且求得的曲线点还可能具有分布于曲线临界点两侧的特性。

In any fatigue analysis, the critical factors are both the magnitude and frequency of load.

在任何疲劳分析中, 关键的因素是双方的幅度和频率的负荷.

Determining critical bending load of compression bar with non uniform cross section

当量长度法确定变截面压杆临界弯曲载荷

Some charts of the critical angle, the critical and limit load coefficients are presented in this paper.

文中还给出了半无限土坡临塑角及临塑和极限荷载系数的计算图表。

This method firstly determines the stochastic characteristic of load margin index through an analysis about the randomicity of parameters which tie up with the tracing of critical point in continue power flow computation, and then figures out the probability of voltage instability by using moment and cumulate method.

该方法通过研究连续潮流计算中与临界点位置密切相关的参数随机变化来确定相应的负荷裕度的随机特性，并在此基础上利用半不变量方法获取所需的电压失稳概率。

A new load distribution domain ( hyper-pyramid ) model critical point of stability considering uncertainties of load change.

考虑了负荷变化的不确定性,提出负荷分布范围的棱锥状模型.