heat time的例句大全

Accumulative quantity of heat time germinate requirement were above 22 ℃.

种子发芽所需热量累积为22℃以上。

the results indicate that it's better to increase the heat voltage and reduce the heat time and length in a proper range.

参数控制实验分析表明，应在有效的范围内减小加热时间和加热长度，提高加热电压。

the determination of dissipating heat time by sprinkling water on the concrete wall

混凝土墙板洒水散热时间的确定

The heat treatment during processing these products will inevitably denature the major components of whey protein, such as bovine α-lactalbumin, β-lactoglobulin, lactoferrin, and so on. The degree of denaturation depends on the temperature and heat time.

而这些热处理过程不可避免地会导致乳清蛋白主要功能性组分α-乳白蛋白、β-乳球蛋白和乳铁蛋白等发生变性，其变性程度在很大程度上依赖于热处理的时间和温度。

that year the heat time is like today, let me forget many details.

那一年跟今天一样酷热，时间让我淡忘了很多细节。

Optionally delay slightly the heat time if the cake batter is much.

如果蛋糕糊较多则需适当延长微波时间.

The average waste heat generating efficiency and the average temperature efficiency are both infected by the exchange time and the optimal exchange time is about 60s.

换向周期对平均余热利用效率和平均温度效率都有较大的影响，其最佳换向周期应定在60s左右。

Results show that the season highways being opened, temperature dropping level and time and material's conductibility of heat ( causes temperature delaying by depth) influence pavement low-temperature cracking, and determine the cracking position.

结果表明，道路开放交通所处季节、温降幅度和时间以及材料的传热性能（导致温度场的滞后）均影响着路面的低温缩裂，并决定了开裂位置的不同。

In the cooling effect of time and symptoms are better than western medicine group. 2, Weng Hua teabag on the wind-heat of the evil caused by sore throat, thirst symptoms better than the evil caused by the wet body weight of fatigue.

在退热时间及症状改善效果方面均优于西药对照组。2、翁花袋泡茶对风热之邪导致的咽痛、口渴症状改善效果优于湿邪导致的身重乏力症状。

But the sum of temperature differences loss would increase, so that the effective heat transfer temperature differences, and at the same time, it will increase the equipment investment.

但效数增加，各效的传热温差损失的总和也将增加，致使有效的传热温差减少，同时设备投资也相应增加，15效是较为适宜的方案。

In researching the method for temperature measurement at transformational superplastic fast thermal cycles, the infra-red brightness temperature measurement instrument was employed. By amplifying its output of temperature signals, the transformations heat effect can be clearly shown at the temperature-time curve.

在相变超塑性快速热循环的温度测量方法研究中，本文选用红外亮度测温仪，将所输出的温度信号进行线性放大，使相变热效应现象在温度-时间曲线上得到明显的显示。

Maximal Relative Temperature and Optimum Switching-over Time for a Thin-wall Heat Accumulator

薄壁蓄热器最大相对温度和最佳切换时间

Finite element analysis of head/ disk continuous sliding contact was performed to investigate temperature field and thermal stress field due to frictional heat using an axisymmetric thermal model. Characteristic temperature rise with sufficient sliding time was exhibited.

采用二维轴对称有限元模型计算磁头/磁盘滑动接触下，铝质磁盘的稳态温度和热应力场以及热退磁临界条件。

There exited mutual interaction effects among the CaCl_2 concentration and transformative time, the heat shock temperature and heat shock time, respectively.

氯化钙溶液浓度和转化时间之间及热休克温度和热休克作用时间之间分别存在交互作用。

The relationships of R, M transformation temperature, hysteresis, transformation heat and aging temperature, aging time were given out.

给出了R、M相变温度、热滞、相变热与时效温度、时效时间的关系。

Totally implicit difference scheme and linear iterative in each time step are used to solve the non-linear equation of coupled moisture and heat transfer.

应用系数效应滞后的全隐式有限差分格式并在每段时间采用线性迭代法来处理非线性水热耦合迁移方程。

At the same time, the depth of die heat affected zone ( HAZ) transfer law and influential mechanism of temperature wave have been analyzed, which lay a foundation for further research of temperature field and thermal stress filed of die. calculation of casing thermal stress;

同时分析了温度波在模具中的传递规律，热影响区范围与影响机理，为进一步开展锻模温度场与热应力场的研究提供了基础。

It is found that temperature wave frequency at a given location in the slab is relevant to slab's thickness and its thermal relaxation time while the amplitude of temperature wave bears a relation with heat source's distribution area and pulse duration.

研究结果表明，温度波动频率取决于平板厚度和材料的热弛豫时间，而其幅值则与内热源释放区域的大小和脉冲宽度的长短有关。

The effects of moving heat source speed, temperature-dependent modulus of elasticity and thermal relaxation time on displacement and temperature are studied.

计算得到了杆内温度及位移的分布规律，分析了移动热源速度、弹性模量以及热松弛时间对温度和位移的影响。

It is proper for middle treatment to adopt high temperature tempering after oil quenching and three-time high temperature tempering is adopted as final heat treatment.

中间处理采用750℃×5h高温回火为宜，最终热处理采用油淬后三次高温回火。