inlet temperature的例句大全

The temperature regulating valves designed for 300 MW units by the institute are mostly placed at the outlet piping of the cooler and a fewer placed at the inlet piping of the cooler.

西北电力设计院所设计的300MW机组，将温度调节阀多数设置在设备冷却器的出口管路上，少数设置在设备冷却器的进口管路上。

The exterior of the tank body is provided with an interlayer water jacket provided with a constant temperature heating device and a water inlet and a water outlet valves.

在罐体外部装有夹层水套，水套中装有恒温加热装置，水套上设有进、出水阀。

On this basis, Different factors such as the type of solar collector, collector inlet water temperature, tank capacity and auxiliary heater, which have big influence on economy, energy efficiency and environmental benefits of SWHS, were studied.

同时，基于该仿真模型，研究集热器类型、集热器进水温度、蓄热水箱容积、不同辅助热源等因素对影响酒店太阳能热水系统经济性、节能效益和环境效益的影响。

temperature difference in the inlet of the accelerating tube

加速管入口温度违

the condensation point is not the only basis for determining the allowable oil temperature at the inlet of heating station.

确定热油管道允许最低进站油温不宜仅用凝点作为选择依据。

data center environmental factors include data center air temperature, humidity, pressure, racks 'inlet and outlet air temperature, power supply and refrigeration equipments' running status.

数据中心的环境要素包括数据中心的环境温度、湿度、气压、各个机架的进风口、出风口温度以及各项供电设施和制冷设施的运行状态等。

the results indicated that the shape of steam plume was influenced by the inlet steam pressure and subcooled water temperature.

结果表明入口蒸汽压力和过冷水温度是影响汽羽形状的主要因素。

Practice proved that the change in the overheater end connection from cross arrangement to parallel arrangement can increase the air preheater inlet fume temperature, principal steam temperature and reheated steam temperature, and reduce the thermal deviation of overheater, and improve the efficiency of boiler.

实践证明，通过调整对流受热面面积，将过热器末段间连接交叉布置改为平行布置，能够提高空气预热器入口烟温、主汽温和再热汽温，降低过热器热偏差，提高锅炉效率。

dip tube carries cold inlet water deep into the tank to minimize temperature dilution of hot water.

将进入的冷水引入内胆底部，将热水温度混合稀释作用降到最小程度。

effect of temperature pulse inlet condition on one-dimensional heat conduction problem

温度脉冲进口条件对单相介质一维非傅立叶导热问题的影响

Therefore, by lowering the temperature of inlet air power and efficiency of gas turbine generators.

本文简要的从热力学角度分析其原因, 同时介绍降低燃气轮机空气进口温度的方法.

Inlet gas humidification greatly influences the fuel cell performance and temperature distribution.

气体相对湿度对电池性能的影响很大.

However, for certain temperaturesensitive materials the inlet gas temperature must be lowered.

但是, 对于某些温度敏感的材料,进入的气体温度必须降低.

The effect of inlet velocity of fluid on temperature distribution was analyzed.

分析了副槽入口风速等参数对转子温度分布的影响.

Sugar cane solution is used as a trial solution in experiment. An evaporative capacity of impinging-stream concentrator is studied by changing inlet air temperature, and the ratio of inlet sugar solution flow rate to inlet gas flow rate and the length of accelerating pipe.

采用蔗糖水溶液作为试验溶液，通过改变空气进口温度、液气质量流量之比、液滴加速管的长度等对撞击流浓缩器（ISC）的蒸发能力进行了研究。

Simulation and analysis of influence of inlet parameters on temperature gradient of floor air distribution system

送风参数对地板送风房间内温度梯度影响的数值模拟及分析

Inlet gas temperature, utilization of cathode gas, flowing pattern and current density has predominant effect on the temperature of stack.

入口气流温度、阴极利用率和电流密度是影响电堆温度的主要因素。

temperature stability characteristic of a double-inlet pulse tube cooler is studied.

针对双向进气结构脉管制冷机稳定性,本文开展了研究.

The additional installment of the temperature detector and alarming equipment at the inlet main steam pipes of turbo generator

透平发电机入口主蒸汽管增设温度检测及报警装置

Study on Some Measuring Technologies of Temperature Distortion on Inlet Flow of Engine

发动机进口流场温度畸变测试技术研究