joint welding的例句大全

Dimension Deviation Analysis of BIW's Welding Joint Based on Energy Method

基于能量法的汽车白车身焊接接头尺寸偏差分析

Magnetic pulse welding ( MPW) is a solid-state joint technology based on electromagnetic forming.

磁脉冲焊接（Magnetic Pulse Welding/MPW）是一种基于电磁成形的固相连接技术。

The joint transition zone measures about 1.5 times the single side in width and the decarbonized zone is nearly 1.5 times the single side, the cutting and explosion welding process is good for better edge welding of stainless steel carbon steel compound sheets;

双面复合界面的结合过渡区约为单面的1.5倍宽，脱碳区也接近单面的1.5倍.采用切割爆炸焊接法有利于改善不锈钢&低碳钢复合板的边缘焊合。

An experimental study of microstructure and properties of the welding joint for two kinds of nippon& made steel

对两种日本进口钢材焊接接头显微组织及性能的实验研究

Study on Influence of Welding Process Parameters on Strength of Welded Joint

焊接工艺参数对焊接接头强度的影响研究

Study on Assessment Techniques of Girth Welding Joint Defects of Oil and Gas Pipeline

长输管道环焊接头缺陷评定方法研究

Study on SSCC Resistance of Girth Welding Joint with Grade X 60

X60钢环焊接头抗SSCC性能研究

The thermal cycle on the surface of friction welding joint was measured by means of thermocouples.

结果表明,摩擦焊接头的温度场、飞边形状和轴向缩短量的计算结果和实验结果吻合较好.

Quality Control of the welding the bellows expansion joint;

波纹管膨胀节总成焊接质量的控制；

In addition, the technological test for all position welding both low carbon steel and stainless steel pipes was carried out, and both the included angle of the joint and the welding parameters for better appearance of weld were optimally chosen as well.

并对低碳钢和不锈钢两种管材的全位置焊接进行了工艺试验研究，优选出了焊缝成形较好的接头坡口角度及焊接规范参数。

Welding Processing and Test Technology on Joint of Concrete Centrifugal Pile

离心管桩接头焊接工艺及检测技术研究

Temperature measure for joint of friction stir welding

搅拌摩擦焊接头的温度检测

Numerical Simulation on Residual Stress Fields and Temperature Fields of Weld Joint in the Process of Fusion Welding

熔化焊焊接接头的温度场和应力数值模拟剂油短时接触催化裂化工艺及催化剂

The test results show that the tensile strength and the impact toughness at low temperature of the welding joint are both slightly lower than that of the base metal.

实验结果表明，焊接接头的抗拉强度和低温冲击韧性都略低于母材值。