light measurement的例句大全

this paper introduces a new method to measure the intensity distribution of single seam diffraction by replacing the silicon photocell and light activated diode with light activated triode. a low noise and high sensitive photo diode detector used in tokamak visible light measurement

利用光敏三极管代替硅光电池和光敏二极管来测试单缝和双缝衍射的光强分布。测量托卡马克可见光谱辐射的低噪声、高响应光敏二极管探测器

polarized light measurement technology on sst

空间太阳望远镜偏振光测量技术

development of plc-based controlling system for three-dimensional structured light measurement

结构光投影三维测量控制系统开发

the object of this paper is trying to develop software on reverse engineering based on structure light measurement for free-form surface.

在此基础上，开发了基于结构光测量技术的自由曲面反求工程软件。

According to the demand for underwater camera modeling and calibration technology of underwater vision measurement, a model of underwater camera is established and a method of underwater camera calibration is presented. First, normal line structured-light measurement method is thoroughly discussed.

本文针对水下视觉测量技术对水下摄像机的建模与标定的需求，建立了一种水下摄像机模型，并提出了水下摄像机的标定方法。

3D Measurement System Technology Research for Free Curve Plan Based on Structured Light Measurement Principle

基于结构光测量原理的自由曲面3D测量的系统技术研究

The principle, method, and implementation optical system of Stockes parameters polarized light measurement in SST are presented. Image Processing related questions are also presented.

文中介绍Stockes参数在太阳空间望远镜中测量偏振光的原理、实现方法与光路的设计结果，并给出了图像处理的相关问题。

ccd camera calibration in grating-type structured light measurement system

光栅型结构光测量系统中CCD摄像机的标定

design of sr extraction mirror for bepc synchrotron light measurement system

BEPC束测系统同步光引出镜设计

The phase-shift technology is applied to monochromatic light interferometry measurement, time-average interferometry measurement and white-light vertical scanning interferometry measurement respectively. By this way, phase information of interferometric fringe can be modulated, which is used in the analysis of MEMS dynamic behaviors.

将相移技术分别应用在单色光干涉测量、时间平均干涉测量以及白光垂直扫描干涉测量中，实现了对干涉条纹相位信息的调制，可以用于MEMS器件运动特性的分析中；

A turbidity sensor, a turbidity titrator, and a method to indicate the titration end-point of precipitation reaction by the measurement of the relative intensity of the scattered light in the titrate solution were introduced.

报道了一种实用的浊度传感器及浊度滴定仪，以及一种利用此仪器检测溶液的浑浊程度（溶液中散射光相对强度）来判断沉淀反应滴定终点的方法。

Through ratio operation of light intensity of different receiving optical fibers, the sensor has completely eliminated the effect of tip surface reflectivity variation on measurement result as well as the effect of inter-angle of tip surface with sensor end surface on measurement result greatly.

通过各组接收光纤光强的比值运算，消除了叶尖表面反射率变化对测量结果的影响，也可减小叶尖表面与传感器端面夹角给测量结果带来的影响。

Measurement of Polarization Coupling with White Light Interferometry and Analysis for Data Sampling

白光干涉法偏振耦合测试及数据采样分析

Method study of the thermal light and its age measurement

方解石的热释光及测年方法研究

An automatic measuring system for the sliding time of submersible motor is designed in the light of the shortcomings of manual measurement.

鉴于手工测量电动机滑行时间存在效率低和误差较大的不足，设计了潜油电动机滑行时间自动测量系统。

The Temperature Resolution of Distributed Temperature Measurement System Based on Single-channel Anti-Stokes Light

分布式光纤测温系统的温度分辨率

The final tip diameter of the fiber probe obtained from experiment was between 40~ 80nm, which was satisfied with the requirements of nondestructive measurement. And the angle of taper was at around 30 °, which might ensure the efficiency of light transmission.

实验得到的光纤探针尖端直径在40～80nm之间，符合细胞内无损测量要求，探针锥形角度大约在30°，很好地保证了光的传输效率。

A new method of slit width measurement system is introduced, in which laser is used as light source.

提出了以激光为光源的微缝宽度测量系统的新方法。

This paper introduces some ways based on the linear analog light-coupler to measure the voltage of single battery in the series-wound Vehicle NI-MH Battery, and designs a battery management hardware system and practical voltage measurement circuit.

本文设计了一种电池管理硬件系统，并介绍几种基于隔离光耦的电压测量电路，设计出一种实用的测量电路。

For the measurement of ambient light interference, designed a set of AC and DC separation circuit, which can effectively separate the red and infrared light hardware timing signals, eliminating the interference of ambient light, improve the working capacity of the system.

为抑制测量环境光的干扰，还设计了一组交直流分离电路，从硬件上有效分隔红光和红外光时序电信号，从而达到消除环境光干扰，提高了系统的工作能力。