maximum temperature的例句大全

This paper introduced an new instrument which was used in thermal hazard analysis-accelerating rate calorimeter ( ARC). Its design principle and inner structure, run modes and the data types including temperature, pressure and the time to maximum temperature rise rate were presented.

本文介绍了一种新型热危险性分析仪器&绝热加速量热仪的设计原理和内部结构，运行模式以及所能获得的温度、压力和最大温升速率时间等数据类型。

In wireless sensor networks, the users often submit spatial window queries to obtain the summary information of a local area in the network such as maximum temperature, average humidity, et al.

在无线传感器网络环境中，用户经常提交空间范围查询以获取网络某局部区域的统计信息，如最大温度、平均湿度等。

And studies on the biological zero, sum of effective temperature, optimum, minimum and maximum temperature, and temperature's influence of aphids' survival rate.

本实验研究了茄粗额蚜的发育起点温度、有效积温、最适温度、最低和最高温、以及温度对其存活率和对有翅蚜产生的影响。

The results indicated that the method could improve the ablative resistance of the composites. The linear ablative rate of the composites at the test surface and the maximum temperature of the backside of the composites were decreased by 7.2% and 20 ℃ respectively.

结果表明通过阳极氧化处理可以改善复合材料的耐烧蚀性能，其线烧蚀率降低了7.2%，背面最高温度降低了20℃。

Heat-resistant ( maximum temperature, the optimum temperature, minimum temperature) is an important basis for identification of heat-resistant species and common species.

耐热性（最高温度、最适温度、最低温度）是同属内耐热与非耐热真菌种级鉴别的重要依据。

The thermal-mechanical fatigue experiments were conducted both with maximum strain in phase with maximum temperature and out of phase with maximum temparature.

热&机械疲劳试验在最大应变与最高温度同相位和逆相位两种情况下进行。

The maximum temperature of the vibrator made of titanium alloy or aluminum alloy is about 1/ 18 of that of 45# steel without heat treatment.

钛合金和铝合金试件的内耗发热温升较慢，其最高温度约为45钢试件的1/18。

The amplitude of pressure spike, the maximum lubricant temperature and the minimum film thickness increase as speed is increased, especially effect on minimum film thickness is significant.

研究结果表明：二次压力峰大小和润滑油膜最大温度随载荷增加而增加，而最小油膜厚度随载荷增加而减小。

The snow cover might affect the daily maximum ground temperature, daily minimum ground temperature and the daily range of the ground temperature.

积雪可能对土壤日最高温、日最低温和日温差有较大影响。

Base on the surface observations of forty years ( 1960-2000), the variational characteristics of annual average temperature, maximum and minimum temperature in Harbin are analyzed.

利用近40年地面观测资料，统计分析了哈尔滨地区各县市的年平均气温及最高、最低气温的变化规律及差异。

Thermogravimetric analysis shows that the regenerated cellulose has lower initial decomposition temperature and maximum weight loss temperature than initial cellulose. It shows poor thermal stability.

热重分析表明，再生后的纤维素的初始裂解温度和达到最大失重速率时的温度都较低，热稳定性较原纤维素稍差。

The corresponding temperature of maximum decomposition rate of different superpolymer is different, thereby the variety of superpolymer can be judged.

不同的高聚物最大分解速率对应的温度不一样，由此可以判断出高聚物的品种。

The viscosity value and temperature at maximum viscosity ( i. e., the temperature reflecting the end of gelatinization) are then read.

在图中可读出粘度值以及在最大粘度值处的温度（即该温度表明糊化的终止）。

By computing the power spectral density and defining a measure parameter, we show that under certain temperature, action potential reach a maximum, which corresponding to the coherence resonance.

通过计算功率谱以及由功率谱定义的β因子，很清楚地看到β在某些温度时达到了最大值，产生了相干共振。

Based on the data of annual and seasonal mean air temperature, minimum and maximum air temperature and precipitation at eleven meteorological stations in Hainan Island from 1961 to 2002, the climatic change of Hainan Island is analyzed.

利用1961～2002年海南岛11个气象站各季和年的平均气温、平均最高气温、平均最低气温、降雨量等资料，对海南岛近42年的气候变化作了较全面的分析。

In addition, radiation absorption coefficient had a remarkable effect on maximum combustion temperature and maximum wall heat flux in the new phosphoric acid tower.

辐射吸收系数对最高燃烧温度和壁面最大热流影响很大，随辐射吸收系数的增大，最高燃烧温度和烟气出口温度会下降，而壁面最大热流和平均热流会上升。

TGA showed that the temperature of maximum speed on loss in weight of PS in composites is80'C higher than that of pure PS.

热重分析表明复合材料中PS最大失重速度时的温度较纯PS升高了约80℃。

Based on the conservation equation of energy, the changing curve of cooling capacity with the outdoor temperature and maximum value were obtained after numerical computing.

在质量守恒、动量守恒、能量守恒方程的基础上，进行数值求解，得出了自然循环的制冷量随室外温度与机组冷剂充灌量的变化曲线。

The final preferendum was about 30.54 ° C, critical temperature minimum was not higher than 45 ° C and critical temperature maximum not lower than 3 ° C.

鼎突多刺蚁的最终适温为30.54℃，临界低温不低于3℃，临界高温不高于45℃；

Critical deformation temperature, maximum deformation, deformation recovery temperature, deformation recovery time of NR/ LDPE materials are investigated in this paper.

研究了天然橡胶／低密度聚乙烯（NR／LDPE）材料的临界形变温度、最大形变量、形变回复温度、形变回复时间等形状记忆性能。