maximum temperature的例句大全

Obviously, infrared temperature of outside surface on west outer wall in cold alley is lower 5 ℃ than that of north outer wall in courtyard at the same time, and both reach their maximum value around 15:00.

同一时刻，冷巷内西外墙外表面的红外温度比庭院的北外墙低5℃左右，且都在15：00左右达到最大。

The electric temperature regulator can also defrost semi automatically. The charger will automatically be turned off as soon as the terminal voltage of the battery being charged approachs to the maximum volume 7. 2 V.

该电子温控器同时具有半自动除霜功能，根据需要，可手动启动除霜加热器，到达设定温度时，自动停止除霜.当蓄电池被充电到最大值&7.2伏特时有自动停止充电的特性。

When the temperature dependency of the material properties is considered, the maximum compressive and tensile stresses are 39.6% and 48.9% less than those of the FGMs with constant material properties, respectively.

考虑变物性时的最大拉应力比常物性减小48.9%，最大压应力减小39.6%；

An interesting phenomenon was found, that is, when laser is focused, the maximum electron density decreases with the progress of plasma absorptive wave, but the maximum electron temperature increases.

研究中发现一有趣现象，在聚焦条件下，随着等离子体吸收波向前推进，最大电子数密度将减少而最大电子温度将增加。

The July maximum (= the highest temperature recorded in July) was 30˚C.

七月的最高气温是30摄氏度。

asymptotic distributions of yearly maximum surface temperature and wind in chongqing district

重庆地面最高气温与最大风速年极值的渐近分布

standard test method for measuring maximum spontaneous heating temperature of art materials

艺术材料的最大自发热温度的测试方法

The time of minimum temperature occurs in transverse joint grouting is also the time when the tensile stress is maximum, making secondary cooling the critical moment for temperature controlling;

最低温度出现在封拱灌浆水冷终了时，此时也是拉应力最大的时刻，因此二次水冷是温度控制的关键时刻；

The higher the initial temperature of fresh concrete is, the higher the maximum principal thermal tensile stress and the crack risk at the surface center node are.

表面中心点的最大主拉应力和开裂风险随浇注初温的升高而增大。

the retractive stress, strain-stress and dynamic mechanical properties have been measured for the isotactic polypropylene ( ipp) samples as drawn and annealed. with increasing temperature, the retractive stress increases, goes through a maximum and then decreases rapidly.

本工作对室温拉伸的等规聚丙烯（iPP）及其退火样品进行了收缩应力、应力应变及动态力学性能测量，得到了在温度升高和降低过程中收缩应力的变化。

the temperature of the expansion water absorbed by the expansion vessel remains under the maximum permissible temperature for the diaphragm.

保持膨胀水箱吸收的膨胀水的温度低于膜片最高允许温度。

establishment of designed outside temperature and analysis of maximum heating load of multi-span greenhouse in china

中国连栋温室室外设计温度确定及最大热负荷分布

effects of temperature and photoperiod on maximum metabolic rates in plateau pikas and root voles

温度和光周期对高原鼠兔和根田鼠最大代谢率的影响

maximum working pressure and super heated steam temperature of stationary steamboilers

陆地安装的蒸汽锅炉最高工作压力和过热蒸汽温度

an n-octane/ stainless steel heat pipe blackbody has been developed with maximum cavity diameter of 60 mm arid working temperature range from 50 ℃ to 200 ℃.

研制了正辛烷/不锈钢热管式黑体辐射源。该源最大口径φ60mm，工作温度为（50～200）℃。

warm-season annual to decadal temperature variability for hokkaido, japan, inferred from maximum latewood density and ring width data

根据最大晚材密度和轮宽资料推断日本北海道暖季年到十年温度变率

base on the result: within the limit of 21%~ 24% of volume percentage of oxygen, with the increase of intake oxygen concentration, maximum cylinder pressure and maximum combustion temperature increase, nox emission increases significantly.

计算结果表明，在氧气体积百分数21%~24%的范围内，随着进气氧浓度的增加，最高燃烧压力和最高燃烧温度增加，NOx生成量增加。

generally, in the same high temperature year, the maximum yield reduction rate of medium rice was larger than early rice.

在相同的高温年份，中稻的最大减产率值一般要大于早稻。

by use of this model, the temperature distribution in the channel can be described and the maximum junction temperature can be calculated.

采用该模型，可描述器件有源层内温度的横向分布，并快速预估沟道的最高结温。

the maximum power point tracking control algorithm adopts incremental conductance of variable step size method, to achieve accurate and fast tracking of the maximum power point under different temperature and different light intensity conditions, and test it through matlab simulation.

采用了变步长电导增量法的最大功率点跟踪控制算法，实现了不同温度和光照强度条件下最大功率点的准确快速跟踪，并通过MATLAB进行了仿真验证。