maximum temperature的例句大全

Base on the surface observations of forty years ( 1960-2000), the variational characteristics of annual average temperature, maximum and minimum temperature in Harbin are analyzed.

利用近40年地面观测资料，统计分析了哈尔滨地区各县市的年平均气温及最高、最低气温的变化规律及差异。

Temperature of maximum weight loss could be decrease to 600 ℃ by grinding, vacuum heat treatment or slow deposition, but it will increased to 800 ℃ after nitrided;

磨削改性、真空热处理及慢沉积均使最大氧化失重温度点提前至600℃，而高温氮化则使最大失重点后移至800℃。

But compared with PP-IFR, the initial decomposition temperature and maximum decomposition temperature of PP-IFR/ MWNTs-COOH were delayed and carbon content were also decreased.

而PP-IFR/MWNTs-COOH复合材料的初始分解温度和最大热分解温度与PP-IFR比较却延后，成炭量也下降。

The results obtained shown that the initial decomposing temperature and maximum decomposing temperature of PU are postponed and the exothermic rate is retarded with adding the thermal stabilizer.

结果表明由于热稳定剂的加入，使PU的外推起始分解温度和最大分解温度推迟，放热速度减慢。

At the centre of the section near the top of burners, its rising velocity is minimum, its turbulence kinetic energy is maximum, and its temperature is maximum too.

燃烧器上部附近的炉膛中心烟气上升速度最小，湍动能最大，温度最高。

The composition of slag lies in 2CaO · Sio_2-liquid biphase zone, and that can assure proper smelting temperature and maximum activity of Cao;

炉渣组成位于2CaO·SiO2－液二相区内，可以保证合适的冶炼温度和最大的氧化钙活度；

The starting temperature, maximum decomposition rate and ending temperature increased with the increasing of heating rate, and the cracking temperature range became wider. However, heating rate had little effect on conversion.

随着升温速率的增加，油页岩热解的初始温度、质量损失峰值、终止温度均增加，而且裂解的温度范围也变宽；升温速率对油页岩的总失重率基本没有影响。

On the basis of high temperature ( maximum 960 ℃), high pressure and severe operating conditions of petrochemical production equipment, the high-temperature cracking and corrosion damages of the equipment in different service environments are described.

根据石油化工设备在高温（最高可达960℃）、高压和恶劣环境下操作的特点，文章阐述石油化工设备在不同环境介质条件下高温劣化和腐蚀损伤的形态。

Based on the data of monthly mean air temperature, maximum and minimum air temperature, precipitation in 1954~ 2000, analyzed the climatic variation and its characteristics in Shache in recent 47 years.

利用莎车1954～2000年的月平均气温、平均最高最低气温、降水等资料，对莎车县近47a的气候变化做了较为全面的分析。

PMN can easily be formed into solid solutions with lead iron niobate, Pb ( Fe1/ 2Nb 1/ 2) O 3 ( PFN) to shift its temperature of maximum dielectric constant ( Tm).

PMN可以方便地与Pb（Fe1/2Nb1/2）O3（PFN）形成固溶体以移动介电常数峰值温度（Tm）。

Influence of Temperature Parameter on Maximum Unbalance Rate of Heating System

温度参数对供暖系统最大不平衡率的影响

Water temperature model and maximum cooling capacity of a lake or pond

湖泊、池塘的水温模型与最大供冷能力的分析研究

Set temperature control to maximum cooling.

将温度控制设置为最强制冷。

With temperature decrease, maximum fibre elongation of cotton decreased and elongation period increased.

随温度降低纤维伸长最大值降低，伸长期延长；

The temperature and the maximum frozen depth of experimental road are measured to verify that the model reliable.

通过对试验路温度和最大冻深计算，验证了水热耦合模型的正确性。

The final preferendum was about 30.54 ° C, critical temperature minimum was not higher than 45 ° C and critical temperature maximum not lower than 3 ° C.

鼎突多刺蚁的最终适温为30.54℃，临界低温不低于3℃，临界高温不高于45℃；

Based on the data of annual and seasonal mean air temperature, minimum and maximum air temperature and precipitation at eleven meteorological stations in Hainan Island from 1961 to 2002, the climatic change of Hainan Island is analyzed.

利用1961～2002年海南岛11个气象站各季和年的平均气温、平均最高气温、平均最低气温、降雨量等资料，对海南岛近42年的气候变化作了较全面的分析。

The snow cover might affect the daily maximum ground temperature, daily minimum ground temperature and the daily range of the ground temperature.

积雪可能对土壤日最高温、日最低温和日温差有较大影响。

The amplitude of pressure spike, the maximum lubricant temperature and the minimum film thickness increase as speed is increased, especially effect on minimum film thickness is significant.

研究结果表明：二次压力峰大小和润滑油膜最大温度随载荷增加而增加，而最小油膜厚度随载荷增加而减小。

The main results are as follows: The best interface temperature, optimum length ratio, and maximum output power of n-type Bi2Te3/ CoSb3thermoelectric materials with wide temperature range were investigated with the intersection method of the ZT curves.

得到了以下主要结果：采用ZT值曲线交点法研究了n型Bi2Te3/CoSb3宽温域梯度材料的最佳界面温度、最佳长度比和该材料构成的n型热电臂最大输出功率。