process conditions的例句大全

Studied the influence of the expanded graphite and magnesium hydroxide as flame retardant additives on fire properties of coating 、 the titanium dioxide and talc as inorganic filler on the coating properties, and confirmed the optimum process conditions.

研究了无机阻燃剂膨胀石墨和Mg（OH）2对涂料耐火性能的影响，研究了填料TiO2和滑石粉对防火涂料性能的影响，确定了最佳工艺条件。

【 Results 】 The optimal process conditions for Flos Datura were as follows: soaking the medicinal material for 2 hours with 10 times of 75% alcohol, with continuous radiation for 25 min at the power of 730 W, at 65 ℃.

【结果】洋金花微波提取的最佳工艺条件是用药材10倍量的体积分数为75%乙醇浸泡2.0h，在功率为730W，温度为65℃的微波条件下连续辐射25min。

The best reaction process conditions as proportion of reacting substance and reaction time, which affected the production rate, were examined.

用红外分光光度计对合成产物进行结构表征，并分析合成反应机理。

According to the simulation results, combined with the actual process conditions, this paper developed a junction termination field limiting ring protected the high pressure Mo/ 4H-SiC Schottky barrier diodes based on experimental results indicate that such planar junction terminal protection structure is very effective.

根据实验结果，结合实际工艺条件，本文研制了具有结终端场限环保护的高压Mo/4H-SiC肖特基势垒二极管，根据实验结果指出此种平面结终端保护结构是很有效的。

A central rotatable method is applied to design a process test of jig dyeing with KE reactive dyes for cotton fabrics, thereby optimizing the most favourable process conditions such as alkali dosage, fixation temperature and fixation time.

用中心旋转法设计了棉织物用KE型活性染料进行卷染工艺试验，优化出最佳纯碱用量、固色温度、固色时间等工艺条件；

it was found that ferrous oxide with particle size less than 40 nm could be prepared by controlling a certain process conditions.

结果发现，在一定的试验条件下，可获得粒度小于40nm的氧化铁。

Use Cross Test Methods to Optimize IC Process Conditions

用正交试验方法优化IC工艺条件

Optimization of the process conditions of addition reaction in the production of antioxidant 1010

抗氧剂1010生产中加成反应工艺条件的优化

The rheological and extrusion contrast tests on PVC resins were made by using RM-200 intelligent torque rheometer and used plastic extruder used in small experiments, and the properties of processing products and processing process conditions were analyzed.

采用RM-200智能转矩流变仪和小型实验用塑料挤出机进行PVC树脂流变及挤出对比试验，并分析了制品的性能及加工工艺条件。

The optimum process conditions in surface modification were obtained: the HA calcining temperature: 1000 ℃, the addition of PL coupling agent: 0.7wt%.

其较佳的表面改性工艺条件：HA煅烧温度：1000℃；偶联剂加量：0.7wt%。

Practice has proved that, after retrofitting the urea reactor with the Type WWS composite internals, the urea output may be increased and the carbon dioxide conversion raised by about 6% under basically the same process conditions.

实践证明，采用WWS型组合内件改造尿素合成塔后，在工艺条件基本不变的情况下，可以增加尿素产量，二氧化碳转化率提高6%左右。

The optimum process conditions of surface modification of wollastonite were suggested as follows: modification reagent stearic acid, modification reagent dosage 2%, modification time 15~ 20 min, modification temperature 70 ℃.

通过对超细硅灰石粉体的表面化学改性效果的研究，确定了最佳工艺条件：改性剂为硬脂酸，改性剂用量2%，改性时间15~20min，改性温度70℃。

Study on Process Conditions of Liquid Culture of Acid-resistant Liquefying-saccharifying Enzyme

耐酸性液化糖化淀粉酶的液态发酵工艺的研究

This paper introduces the basic principle and process conditions of single crystal silicon growth by Cz method.

介绍了直拉法生长单晶硅的基本原理及工艺条件。

The selection of process conditions such as the dosage of binder SX in pigment printing, curing temperation and curing time was discussed.

探讨了粘合剂SX在印花工艺中用量、焙烘温度、焙烘时间等条件的选择。

The characteristics of superdeep aeration, the equipment structure, the process conditions and the treatment results of applying such technique to paper-making wastewater have been concluded in brief in the paper.

叙述了超深层曝气方式特征，并就造纸废水处理的设备结构、设备条件、工艺流程以及处理结果等作了简要的介绍。

CDP fibers with higher breaking strength were obtained under the process conditions of a large amount of air for crystallization, low temperature dry, lower spin temperature, mildly cooling, proper melt filter accuracy and higher draw and winding speed.

采用大风量结晶，低温干燥，较低的纺丝温度，缓和的冷却条件及合适的熔体过滤精度，在较高的拉伸、卷绕速度下可制取具有较高断裂强度的四组分阳离子可染聚酯纤维。

Optimum process conditions of extracting sesame protein and oil by aqueous extraction

水提法从芝麻中提取蛋白质和油提取条件的优化

n hydroxymethylation and amination of polyacrylamide were studied, and the effects of process conditions on the rate of hydroxymethyl group and amino group combined on polyacrylamide were investigated.

对聚丙烯酰胺的N羟甲基化及氨基化过程进行了探讨，研究了工艺条件对羟甲基化率和氨基化率的影响。

optimization of process conditions for recovering indium in coke dust from zinc vertical retorting

从竖罐炼锌焦结烟尘中回收铟工艺条件的优化