quenched的例句大全

Skiving quenched gear teeth surface with hard alloyed hobbing cutter

用硬质合金滚刀刮削硬齿面

Products quenched by this technique possess of many advantages such as deep quenched layer, good combinations of mechanical properties, low residual stress, high resistance to cracking and high precision, etc.

它具有淬透层深、综合力学性能好、残余应力值低、变形开裂小、精度高等优点，对解决高精度细长冷轧辊等工件的淬火有很好的效果。

It's like I was parched, and she quenched my thirst with a big goblet of "Wow."

就像在我口渴得要命时，她用一大杯惊喜之酒来为我解渴。

recovery of copper from water quenched slag of copper smelting by impoverishment at high temperature and flotation

高温贫化-浮选法从炼铜水淬渣中回收铜漳村矿选煤厂浮游选煤加药自动化研究

The unit cutting forces during high speed milling of this high strength steel were 1.0729~ 1.7917 times of that measured on quenched and tempered 45 median carbon steel; In the ultra-precision milling, the cutting forces are very low.

该类型高强度钢的单位铣削力为45调质钢的1.0729倍～1.7917倍；超精密铣削中铣削力水平较低，如铣削深度小于10μm时，铣削力不超过1N。

and the active components of catalysts deposit on the burning surface of propellants and the quenched surfaces of propellants with various catalysts possess different structure.

催化剂分解的活性组分富集在燃烧表面，不同催化剂使推进剂熄火表面形成不同的结构。

Two sword and one halberd found in YANXIA, Hebei of China, had "MA structure" in its micro-composition which was quenched.

中国河北省易县燕下都出土的两把剑和一把戟，其显微组织中都有马氏体存在，说明是经过淬火的。

The microstructures of the steel are fine lath martensite after "zero time holding" quenched.

零保温淬火后可获得细小的板条状马氏体组织。

"For the light of the sinner is put out, and the flame of his fire is not shining." His unjust unkindness, that in all reason should have quenched her love.

恶人的亮光必要熄灭。他的火焰必不照耀。照理说，他的无情无义应该叫她的爱情熄灭下来。

This paper uses the Finite difference method to study the responding temperature value of the tooth back when the tooth is quenched by laser and gives the relation charts of temperature value with laser parameters and gear parameters.

针对齿轮激光表面淬火背面回火现象，采用有限差分法分析研究了背面温度响应值，并给出了温度响应值与激光工艺参数、齿轮参数的关系线图。

Torsional fatigue experiments were carried out with aluminium-magnesium alloys containing 0.52, 0.91, 3.46 and 5.15% magnesium at the quenched state, and △ E-N and Tm-N curves were determined.

本文进行了淬火状态的、含0.52,0.91,3.46和5.15%Mg的铝合金的扭转疲劳试验，测定了相应的ΔE-N曲线和T m-N曲线。

Axis of all sorts of gear inside gear-box, spline, send all sorts of an axle shaft, small axles, all sorts of dialing fork high frequency quenched processing;

变速箱内各种齿轮、花键轴、传支半轴、各种小轴、各种拨叉等高频淬火的处理；

While the bearing roller is quenched into UNCON ( 15w%) or water, it can get a lot of martensite. At the same time, the hardness and quenching layer of bearing roller meets the needs, but the residual stress is larger.

以UNCON（15%）或水为淬火介质时，可以得到大量的马氏体，支承辊硬度和淬硬层深也符合要求，但残余应力较大。

For example, a piece of nitinol wire bent to form a circle that is then heated and quenched will remember this shape.

比如，一节镍钛诺线圈在加热冷却后会记住圆圈这形状。

A metal with a memory, it can be made to remember any shape into which it is fashioned, returning to that shape whenever it is heated. For example, a piece of nitinol wire bent to form a circle that is then heated and quenched will remember this shape.

这是一种有记忆力的金属，人们可以使它记住它被塑成的任何形状，并在加热后恢复这一形状。比如，一节镍钛诺线圈在加热冷却后会记住圆圈这形状。

Because they have forsaken me and burned incense to other gods and provoked me to anger by all that their hands have made, my anger will be poured out on this place and will not be quenched.

因为他们离弃我，向别神烧香，用他们手所作的惹我发怒，所以我的忿怒如火倒在这地上，总不息灭。

The British Standard grade 460 bars, which when quenched with left heat after rolling, are naturally aged for different times.

对采用轧后余热处理工艺生产的英标460级钢筋进行不同时间的自然时效后测定其力学性能。

Rapidly Quenched Skeletal Ni Catalyst: Its Characterization and Catalytic Behavior in the Hydrogenation of Some Unsaturated Organic Groups

猝冷骨架Ni催化剂的表征及不饱和有机官能团加氢行为研究

The results showed that BSA had strong intrinsic fluorescence, which could be quenched by seven pesticides in a static process mainly, but also accompanied by non-radiative transfer of energy.

结果表明，BSA是具有较强的内源荧光，这7种农药对其荧光以都是静态猝灭为主。同时也伴随了能量的非辐射转移；猝灭过程中，其结合位点均为1。

Glass was heated to its softening point and reshaped in mold under its gravity in heating furnace, then was sharp quenched by cold blast immediately.

重力钢化炉的成型、钢化主要是将玻璃加热软化，玻璃在重力作用下沿成型胎边框模周边下弯成型，再将玻璃由加热炉移至急冷设备风栅间淬冷钢化。