shear strength的例句大全

Evaluation of the life by means of the shear strength of sample which pass through heating oxygen aging test according to environmental test specification was.

以拉剪强度为特性指标，通过热氧加速老化试验，参照环境考核试验，综合评估其使用寿命。

Study on Shear Strength Characters of Pb/ Sn Bump

Pb/Sn凸剪切性能研究

Experimental research on shear strength of basalt fiber composites reinforced by thermosetting resin

热固性树脂基玄武岩纤维复合材料性能的研究

Theoretical model on shear strength of reinforced fiber concrete beams

钢筋钢纤维混凝土梁斜截面抗剪强度的理论模式

The effects of rolling and annealing temperatures on the shear strength of titanium cladding steel plate were investigated.

研究轧制温度、退火温度对复合板剪切强度的影响。

According to the relationship among structural stiffness, structural compression resistance, shear strength, and mortar strength, the masonry strength and mortar strength are obtained. And then, the quality and safety of masonry buildings are evaluated.

根据识别的刚度矩阵，利用结构刚度与层间抗压抗剪强度、砂浆强度之间的关系，则可求得砌体的强度，从而达到对砌体结构进行损伤检测和安全性评定的目的。

Making use of the test features of ring shear apparatus, the change law of shear strength of soils under large shear displacement can be studied.

利用环剪仪的试验特点，可以研究土体在较大剪切位移下抗剪强度的变化规律。

Study on improved double-notch shear strength test of glass laminates

复合材料层合板双切口层间剪切试验的改进研究

Theory of Shear Strength for Normally Consolidated Saturated Clay

正常压密饱和粘土的抗剪强度理论

A solvent-free room-temperature curable two-component PU adhesive was prepared, it has higher adhesion strengths and excellent toughness. The shear strength at room-temperature was 37.1 MPa and the shear strength at 200 ℃ was 3.8 MPa, and the tensile elongation at break still was 104%.

研制了一种室温固化无溶剂双组分聚氨酯胶黏剂，具有较高的黏接强度及良好的韧性，在保持室温剪切强度为37.1MPa的同时，扯断伸长率为104%，200℃仍有3.8MPa的强度；

The paper introduces the synthesis and properties of the adhesive, discusses that shear strength can be affected by the thickness of adhesive layer and drying time of the test-piece which has been immersed in water for 24 hours.

介绍了它的合成方法和性能，讨论了粘接试件浸水24小时后的不同自然干燥时间、胶层厚度等对剪切强度的影响。

Experimental Study on Shear Strength and Anchorage Behavior of Steel Tie Bar and Expansion Bolt in Shale Perforated Brick Masonry

页岩多孔砖砌体抗剪性能与拉结筋、膨胀螺栓锚固性能的试验研究

Shear Strength of the Soil Contrasted by testing in Site and laboratory

土的抗剪强度原位测试与室内测试的对比

Titration analysis, AFM and composites IFSS measurement were used to characterize the acidic functional groups contents on the fibers surface, the surface topography and its composites interfacial shear strength.

通过酸碱滴定法、原子力显微镜表征和复合材料界面剪切强度（IFSS）测试，分析纤维表面酸性官能团含量、表面形貌及其复合材料界面强度的变化规律。

Aiming at anti-slide performance and anti-seepage performance in pavement performance we measured the texture depth and water permeability coefficient. Finally, we researched on interlaminar shear strength between the micro surfacing and pavement using the determined gradation and the optimum emulsified asphalt content.

路用性能测试主要针对抗滑性能和防渗水性能进行了构造深度和渗水系数的测定。最后，采用确定的级配和最佳改性乳化沥青用量，研究微表处与原路面的层间剪切性能。

Analysis of Shear Strength of Reinforced Concrete Beams with Inclined Tension Side

受拉边倾斜的钢筋砼梁受剪承载力的解析解

The basic concept suggested by the second author in 1984,1986 have been extended to apply to beams with inclined tension side and the shear strength of such beams has been analyzed in this paper.

本文将蒋大骅（19841986）提出的基本概念推广到受拉边倾斜的钢筋砼梁，对其受剪承载力进行了研究。

Testing methods for shear strength of adhesive bonds by tensile loading

用拉伸负荷测定粘合剂剪切强度

This paper aimed at acquiring the real interlaminar shear strength in tension test.

在拉伸负荷方式下，层间剪切强度的测定受弯曲力矩的影响。

The melting point and the shear strength of Bi-Pb-Sn-Cd fusible alloys were determined by DSC and tension tester.

利用差热分析仪和拉伸试验机，研究了易熔合金Bi-Pb-Sn-Cd的成分对合金熔点和剪切强度的影响。