standard temperature的例句大全

Based on the monthly air temperature from 26 representative stations in Qinghai from 1961 to 2002, the standard weighted average air temperature sequence was given, and the characteristics of air temperature variation in recent 42 years in Qinghai was analyzed.

利用青海省26个代表站1961~2002年气温月资料，给出了加权平均的气温标准序列，分析了青海近42年来气温变化特征。

This system is composed by a temperature chamber, several switch groups, a PC computer, a high-resolution frequency meter, a frequency standard, a control system including a simulator and a controller, a human interface based on virtual instrument.

该开发系统由温控柜、多路开关组、PC机、高分辨率频率计、频率标准、控制系统、基于虚拟仪器的人机界面组成。

The friction behavior of three kinds of graphite used for nuclear reactors was tested by SRV standard high temperature friction tester under the helium and air environments The friction coefficients for the three kinds of graphite all increase with the friction speed increases.

在高温摩擦实验机SRV上对三种反应堆用石墨的摩擦系数进行了测试，实验条件分别是高温气冷堆冷却剂氦气环境和空气环境。

There is no finalized test device for standard short-model couple, because that it's difficult to realize the constant and uniform temperature field for test furnace of the thermal couple.

由于短型热电偶检定炉的恒定均匀温场难以实现，所以，国内没有定型的标准短型热电偶检定装置。

Take full account of the preparation of standard test sample, set of device parameters, temperature and other details on the polyethylene pipe specimen, constant strain rate tensile, creep test and relaxation test are accomplish.

充分考虑标准试验试样制备、设备参数设置、温度调节等细节，对聚乙烯管试样进行等速率拉伸、蠕变、松弛试验，通过合理的试验处理得到真实应力应变曲线以及力学性能参数。

In this paper, based the standard effective temperature SET as the thermal comfort control index, a test controller of the single air-conditioning, ceiling fan and windows three coordinated control was studied to make indoor thermal environment of the SET value in a comfortable range.

本文以标准有效温度SET为热舒适控制指标，研究了一个实现单体空调、吊扇和窗户三者联动控制的实验控制器，使室内热环境的SET值处于舒适的范围之内。

The equilibrium geometries of the reactants and products were optimized and the standard thermodynamic parameters in different temperature ranges ( 298~ 1573 K) were calculated.

对反应物和产物的结构进行了能量梯度法全优化，计算了不同温度下（298～1573K）的热力学参数。

This standard describes the procedure for obtaining the Hydrostatic Design Stress ( maximum working strength) for any thermoplastic pipe material at any practical temperature.

这个标准描述了获得流体静力设计应力（最大工作强度）的步骤，用于任何实际温度下的任何热塑塑料管道材料。

The standard K-ξ model of steady turbulent flow in software FLUENT is used to simulate the interior airflow field. Three-dimensional velocity and temperature field are obtained.

对室内气流场的模拟，采用FLUENT软件中的标准k-ξ模型进行稳态湍流流动的数值模拟，模拟结果分别得到了室内气流的三维速度场、温度场等。

Results Indoor air temperature and relative humidity accorded with second class standard of 《 Threshold limit values for space and environment of camping movable shelter system 》 in winter, indoor air exchange attained 1 time per hour, which also reached request of the usage.

结果室内热环境参数温度和湿度指标冬季可以达到《野营住房空间与环境限值标准》中的二级标准，冬季室内的换气次数可以达到1次/h，也达到了使用的要求。

Besides, the power spectral density of the images, the standard deviation of the density, and the unevenness are also changed with temperature rising, it is consistent with the experimental results of tissue protein solidification in microwave ablation.

此外，图像功率谱密度、密度标准偏差、不均匀度等也随着组织的温度升高而变化，这与高温消融情况下组织蛋白固化的实验现象相符。

Base on the temperature field, the optimization method of well group arrangement to avoid thermal interference among wells and to reduce occupied area, and the evaluation standard of the optimization arrangement of wells, were pointed out.

在模拟出井群温度场的基础上，提出了如何避免井间热干扰以及减少用地面积的井群优化布置的方法，并提出了井群优化布置的评价标准。

A new method for direct measuring interface temperature and its distribution along diameter direction for friction welding joint between the same or different materials is put forward by using the standard thermal couple in combination with natural thermal couple.

将标准热电偶与自然热电偶两种测温方法结合起来，提出了一种能直接测量同种及异种材料摩擦界面温度及其沿径向分布的新方法。

When the mass concrete is constructed in winter, according to the standard requirement, the temperature differential between the internal and surface of concrete is under controlled by the thickness of the thermal insulating materials to avoid appearing cracks.

大体积砼冬期施工，通过控制保温材料厚度，使砼内部与表面温度差控制在规范规定之内，实现不产生裂缝的要求。

A Calculation Method for the Output Noise Temperature of Standard Thermal Noise Source

一种热噪声标准源等效输出噪声温度的计算方法

This formula has been applied to determine the available noise temperature of the thermal noise standard source.

该计算式已被用于确定热噪声标准源的资用噪声温度。

This paper gives the suggestions for clauses on thermal limiting output, accuracy class, temperature rise of electromagnetic unit, short circuit withstand capability and ferro-resonance in the standard of GB/ T4703.

提出对GB/T4703标准中热极限输出、准确度、电磁单元温升、承受短路能力和铁磁谐振条文的修改意见。

Thermal relaxation regularities that consistent with the Arrhenius relationship are observed in the low-frequency experiments. Introducing the thermal relaxation regularities into the standard linear solid model, the thermal relaxation model with effects of both frequency and temperature is obtained.

由低频实验获得了符合Arrhenius关系的热弛豫规律，将其引入标准线性固体模型中，得到了同时含有频率和温度效应的热弛豫模型。

The results showed that, the higher temperature in earlier curing stage could accelerate the reaction speed of blended cement and increase the reaction degree, but it would affect the increase of reaction degree in later standard curing stage.

研究结果表明，早期较高的养护温度可加快混合水泥的反应速率，提高其反应程度，但对后期标养条件下混合水泥反应程度的增长有影响；

Some practical problems arising from the adoption of the absolute scale of temperature as standard

在选绝对温标为标准后所引起的一些实际问题