standard temperature的例句大全

the result of stibium electrode's determining ph values of two standard buffer fluid in laboratory showed that the maximum absolute error was 0.23 when temperature went below 60 ℃ and 0.46 when 70 ℃.

室内实验中锑电极测定两种标准缓冲液的pH值，当温度小于60℃时，最大绝对误差为0.23；温度为70℃时为0.46。

In this paper we give a more detail introduction about drawing principle and recognition of relation curve of standard free energy of oxidation reaction changes from temperature. Further more we discuss the laten application of the method to exploit the regularities of dry oxidation-reduction reaction at high temperature.

介绍了氧化反应标准自由能变与温度关系图的制作原理以及对图的识别，进一步认识并掌握这种图解方法在研究高温干态氧化还原反应变化规律中的应用。

At last, to analyze the errors and validate the system on the standard A lamp, we did some tests for the candle flame temperature distribution, and got good result.

最后对火焰温度测量系统进行误差分析，并运用近似黑体的标准A光源对测量系统进行标定，建立了一种温度分段线性拟合的方法，通过实际对蜡烛火焰的测温试验，得到良好的测温结果。

The design of a precision temperature controller used in spectral radiance standard detector

一种新型基于半导体致冷技术设计的精密温控系统在光谱绝对辐亮度标准探测器中的应用

The released heat will heat the 'cold' universe to Planck temperature, so the created inflationary universe will pass into the standard model dominated by radiation.

这样所创生的宇宙即由原初暴涨阶段过渡到以辐射为主的标准模型。

A high price, temperature, fever, speed, wind, living standard

高价、高温、高烧、高速、大风、高的生活水平

Through analysis of the reason causing temperature rising of bearing tile of steam turbine thrust, have probed into the method of solving problem of temperature exceeding standard of thrust tile is provided.

通过对造成汽轮机推力轴承瓦块温度升高的原因进行分析，探讨了解决推力瓦块温度超标的方法。

The flow calculator transfers the flow rate, pressure, temperature analogue signal to digital, then calculates the real time flow in standard condition and cumulates the flow. The real time flow, cumulate flow, history flow, pressure and temperature are displayed on the LCD.

流量积算仪采集4～20mA的流速、压力和温度信号，计算出实时的标准状况流量，然后对流量进行累积计算，通过液晶显示屏显示实时流量、累积流量、温度、压力以及历史流量。

It's quite difficult to test the maximum power of the electric motor for short-time work, not to mention the measurements under standard voltage and temperature. Nowadays.

对短时工作电动机最大功率的测量是困难的，要在标准电源、标准环境温度下的测量更加困难。

Therefore, according to the international standard of the fire protection for the railway train& British fireproofing standard, in the paper the experimental research and finite element simulation under high temperature were carried out.

因此，本文根据轨道列车防火的国际标准&英国防火标准，进行了复合阻燃陶瓷涂层的实验研究与有限元高温模拟。

In order to solve nonlinear errors in measurement, the principle of the black body radiation temperature sensor of optical fiber and nonlinear error source are analysed. The composition of measurement circuit is given, and temperature calibration had is carried out with standard Platinum-Rhodium thermocouple.

为了解决测量中存在非线性误差问题，分析了光纤黑体辐射温度传感器的原理和非线性误差的来源，给出了测量电路的组成，并利用标准铂-铑热电偶进行温度校正。

A critical temperature of water is 100 degrees C& its boiling point at standard atmospheric pressure; critical mass; go critical.

水的临界温度是摄氏100度&标准大气压下的沸点；临界物质；达到临界。

Establishes an empirical formula relating temperature to saturated humidity ratio under standard atmospheric pressure by means of polynomial regression. Analyzes the calculating error in common engineering temperature range, and the error is less than 2.1 percent.

利用多项式回归拟合了标准大气压下温度与饱和含湿量之间的经验公式，并进行误差分析，认为在工程常用温度范围内，计算误差小于2.1%。

This actuator is used only on models equipped with the standard manual temperature control system.

这种引动器仅用于装有标准手动温度控制系统的车型。

The coating powder fabricated in this experiment, its antioxidation temperature is above 850 ° C, and it can satisfy the requirements of high temperature sintering at standard atmospheric pressure.

实验制备的包覆粉，其大气下抗氧化温度在850℃以上，能够满足大气下高温烧结的要求。

A method for realizing the spectral radiance standard with level ( 50~ 500) cd/ m 2 is presented. It is based on the national secondary standards of luminous intensity and color temperature, halogen lamp and white diffusing plate smoked MgO.

介绍了一种使用溴钨标准灯、烟熏MgO漫反射白板、国家光强度副基准及国家色温度副基准建立（50～500）cdm2亮度水平下光谱辐射亮度标准（380～780）nm的方法。

When the temperatures of supply and return water are between 30 ℃ and 40 ℃, the change range of average floor surface temperature is between 24 ℃ and 26 ℃, which meets the radiant floor heating standard.

当供回水温度为30~40℃时，地板表面平均温度的变化范围为24~26℃，符合地板辐射供暖标准。

Stick the adhesion tape to the test board, put the adhesive tape in the hot temperature, lower end suspension standard loading, test the tape adhesion time.

将胶带粘于实验板上，胶带试片于热温环境中，下端悬挂标准荷重，测试其胶带粘着时间。

standard test method for measuring maximum spontaneous heating temperature of art materials

艺术材料的最大自发热温度的测试方法

standard specification for phase change-type disposable fever thermometer for intermittent determination of human temperature

人体温度周期性测量用相位变化型易处置体温计的标准规范