stress element的例句大全

The material is simulative analyzed by finite element method, the results show: the arised thermal stress of the slide plate in practical use mainly results from the initial temperature.

用有限元进行了模拟分析，结果表明：滑板在使用过程中产生的热应力主要决定于其初始温度，根据应力分布情况可以优化滑板结构。

Using finite element software to analyzes temperature effect of overlong concrete structure on the condition of four different restrains, and the imitating results proof that the temperature stress was reduced efficaciously by setting the sliding floor, therefore alleviate the crack of the concrete structure.

对超长混凝土结构在四种不同约束状态下的温度效应进行了模拟分析，论证了在超长混凝土结构底板采用滑动摩擦处理能够有效的降低底板温度应力，缓解混凝土开裂。

Based on the calculating analysis of nonlinear finite element the stress level method of researching the stability of slopes and confirming the most dangerous sliding plane is proposed. The example confirms that the stress level method is feasible and practical.

基于对边坡的非线性有限元分析，提出了一种研究边坡稳定性和确定边坡最危险滑动面的应力水平法，并通过工程实例验证了该法的可行性和实用性。

Numerical simulation is conducted by nonlinear finite element method. And the distribution of concrete cracks, stress contour figures, strain contour figures, load-displacement curves and slip distribution curve are acquired.

对构件进行了非线性有限元分析，获得了构件中混凝土裂缝分布图、应力云图、应变云图及荷载&位移曲线图、滑移分布图等。

The limit equilibrium method and finite element analysis method are currently the main method of slope stability analysis. Finite element method includes finite element strength reduction and FE slope method based on slip stress.

极限平衡法和有限元分析方法是目前进行边坡稳定分析的主要方法，其中有限元法包括有限元强度折减法和滑面应力分析法。

Stability Analysis of Deep Foundation Pit Soil Nailing Supporting Structure Based on Finite Element Slip Surface Stress Method

基于有限元滑面应力法的深基坑土钉支护结构稳定性分析

We use a finite element method to study evolution of theoretical displacement, stress and strain field with a growing displacement applied at the remote plate ends, when fault slip and frictional stress are not given in advance but are determined in the solving process.

使用有限元素法研究了理论位移场、应力场和应变场随远场位移的演变情况。此时，断层位移和磨擦应力并不是预先给定而是在求解过程中同时确定的。

Because the finite element method consider the relation of stress-strain of rock soil, So, it is more accurate and rational than other methods that it calculates side slope stability coefficient.

由于有限元计算方法考虑了岩土的应力&应变关系，因此，其求解的边坡稳定系数比其它方法更为精确合理。

The finite element method was used for analysis of heat stress in chip on board ( COB).

本文采用有限元法分析了板上芯片（COB）的热应力分布。

Finite element numerical solution of fatigue life of mechanical member and of stress intensity factor K and J-integral for 3D model is approached with ANSYS software. An important method is made for the fatigue analysis and fatigue performance of winder axle.

本研究探讨了利用ANSYS软件分析机械构件疲劳寿命和三维模型断裂参量K和J积分的方法，为提升机主轴的疲劳分析和断裂性能研究提供了一种重要手段。

Effect of belt angle on stress of an all steel cord truck radial tire by finite element analysis

带束层角度对全钢子午线轮胎应力影响的有限元分析

The collar rim, the element of the lunar rover plays an important role as component of bearing stress in the process of moon exploration.

轮圈作为月球车车轮的重要承力构件，在月球车的研制中起到非常重要的作用。

A three layer cylinder model containing alloy, steel lining and housing was established. With the help of finite element method ( FEM) software package ANSYS, and considering the stress change along alloy thickness, the bearing stress especially in alloy layer was calculated.

建立了合金层、钢背和轴承座的三层圆筒模型，利用ANSYS软件对轴瓦应力，尤其是合金层应力进行了计算，计算过程中考虑应力沿合金层厚度方向的变化。

Considering the number of rollings of bearings, rollings diameter and curvature coefficient of inner and outer race and other factors, the deep groove ball bearings for finite element analysis, effects of various factors on the bearing contact stress and deformation.

综合考虑滚动体数量、滚动体直径及内、外沟曲率系数等因素的影响，对深沟球轴承进行有限元计算，得到各因素对轴承接触应力和变形的影响。

The effect of distribution status of film pressure of journal bearing on shaft stress is studied by finite element method on condition that the boundary condition of load is made by lubrication analysis of journal bearing.

根据轴承润滑分析结果，确定载荷边界条件，应用有限元方法研究了轴承油膜压力分布形态对轴应力的影响。

For the high strength reinforced concrete arc shaft wall, its mechanical characteristics including the radial displacement, the concrete stress, the reinforcing steel bar stress, the load carrying capacity and the position of crushing zone are analyzed by experiment and finite element calculation under uniform load.

通过实验和有限元计算，对在均匀荷载作用下新型冻结井高强钢筋混凝土弧形板井壁的变形特性、混凝土和钢筋应力的分布规律、极限承载力及其压碎区的位置进行了分析。

Its distributing of stress is simulated by finite element analysis software order to compare their fixedness.

并使用有限元分析软件对不同微桥进行结构分析，以比较其稳固性

The temperature field and thermal stress of tee pipe sockets for exhaust pipes to atmosphere from reheater have been analyzed by using the finite element method, the data at time points of 50, 200, and 400 minutes after startup being discussed.

进行了再热器对空排气管三通管座的温度场和热应力的有限元分析，并选取机组起动后第50min、200min和480min3个点的数据加以讨论。

Through the three-dimensional finite element analysis modeling, the text analyzes the influencing rule and outstanding function of the load stress 、 the thermal stress and coupled stress to asphalt surface course's thickness 、 base's thickness 、 modulus and the foundation's modulus.

利用三维有限元模型，分析了沥青面层厚度、基层厚度、基层模量和地基模量等参数对刚性基层的荷载应力、温度应力及其两者之间的耦合应力的影响规律及其显著性。

Stress analysis of hem pyramidal heads in transitional section with finite element method

折边锥形封头过渡区应力有限元分析