tank liquor的例句大全

The growth and property of oxidized film are restricted by various factors such as tank liquor temperature, sustained oxidation time, alloy composition, current density and sulphuric acid density.

而氧化膜的生长和性能要受到槽液温度、持续氧化时间、合金成分、电流密度、硫酸浓度等多种因素的制约。

In this paper, a mathematical model and direction for use of testing the concentration of tank liquor by regression analysis are proposed based on the study of a specific problem. [ WT5FZ]

在对具体问题研究的基础上，给出用回归分析方法测试槽液浓度的数学模型和使用说明。

Regression Analysis Applied in Measuring the Concentration of Tank Liquor

回归分析在测试槽液浓度中的应用

Dubs in the tank liquor to dissolve directly, other accessory material are specially the organic alkyl, the nickel member chemical additive, must supplement in proportion.

直接加配槽液溶解，其他辅助材料特别是有机烷基，镍分子添加剂，也必须按比例补加。

Testing the concentration of tank liquor is a common problem in the industry.

槽液浓度测试问题，在厂矿企业为常见问题。

YWH Filter is a high efficiency filter of new type, mainly made up of tank shell, liquor pump, valve box, pipe joint and the control system. The requirements to its manufacture process and quality control are very strict.

YWH型过滤器是一种高效率的新型过滤设备，主要由罐体、液化泵、阀体、管汇及其控制系统组成，制造工艺和质量控制要求严格。

There are two side tanks for alternating outlet. Additional settling tank, sludge and mixed liquor recirculation equipment are omitted. This process runs at constant water level with small water head loss. Power consumption is greatly saved because of low power load.

其中有两个边池交替出水，不需要单独设置沉淀池，省却了污泥和混合液回流设备，恒水位运行，水头损失小，装机负荷低，可以大大节省动力消耗。

The application of blower fan in the defoaming of black liquor tank in the extraction section

风机用于提取段黑液槽消泡的探讨

agitate the green liquor in the dissolving tank relevantly.

保持溶解槽中绿液的适当液位；

Quick Examination of Mixed Liquor Suspended Solid in Aeration Tank Using Moisture Analyzer

利用水份测定仪快速测定曝气池污泥浓度

Results The optimum forming technics could be seen as follows, the height of the drug storage tank was 3 cm, the temperature of drops was 80 ℃, the dropping distance was 5 cm and the temperature of the liquor condensate was 15 ℃.

结果：最佳成型工艺为贮药槽药液高度3cm、滴头温度80℃、滴距5cm、冷凝液温度15℃。

Reasons and countermeasures for mother liquor holding tank wall thinning down of high density polyethylene device

大庆高密度聚乙烯装置母液储罐罐壁减薄原因及措施

The reasons and countermeasures for mother liquor holding tank wall thinning down of high density polyethylene device were analyzed in this paper.

本文从大庆石化公司高密度聚乙烯装置的生产实践出发，对造成母液储罐罐壁减薄的原因进行了分析，并提出了相应的对策。