taper的例句大全

The technique of optical fiber-taper coupled with CCD is widely used in the imaging system of space payload, low light level night vision system, television tracking of missile system and remote sensing imaging system.

光锥与CCD耦合技术可广泛应用于航天有效载荷的成像系统、微光夜视、导弹电视跟踪和光谱遥感成像等系统中。

In this article, the control principle of coiler tension is generally introduced. Some calculation methods for coiler tension torque, torque compensation, coil diameter and taper tension unit are described in detail.

简述卷取张力控制原理，并着重论述了卷取张力力矩、力矩补偿、钢卷直径、TAPER张力环节等检测与计算方法。

Unlike other trees, it doesn't taper very much. It stays fat all the way up

和别的树不同，它不是越往上越细，而是上下一样粗。

technical conditions for hand taper 1: 50 pin reamers

手用1：50锥度销子铰刀技术条件

According to the Fourier transform relationship exists between the array factor and the element excitations in thinned array, an iterative fast Fourier transform algorithm based on the classic density-tapered array optimization design is presented and the detailed theory of the method is discussed. 3.

根据稀疏阵列中阵列因子与阵元激励之间存在的傅里叶变换关系，在经典密度加权阵列设计方法的基础上，完善了一种基于迭代FFT算法的阵列优化方法，并详细阐述了其原理。

Based on relevant operation results, it is concluded that under the precondition that all the thread element data like taper and pitch remain consistent, it is feasible to substitute the pitch diameter gauge and the ovality gauge for the thread work gauge.

结合生产实例分析指出，在锥度、螺距等螺纹单项参数合格稳定的情况下，用中径和椭圆度量规替代螺纹工作量规是可行的。

The results showed that the major cause of thread gluing is over plastic deformation of partial thread face, and that the distribution of contact stress can be improved with the taper mutation, which has proved to be effective in the factory manufacturing.

认为产生粘扣的主要原因是螺纹齿面局部过量的塑性变形，通过变锥度的方式能使接触应力分布规律得到改善，并在现场生产中得到验证。

Laser Beam propagation through a Taper-like GRIN Rod Lens and Its Applications

激光束经类锥形梯度折射率纤维的传播理论及其应用

This machine is controlled by the industry control computer, which can measure the clearance along the driving taper gear axes and select the suitable sleeves so that the clearance can be eliminated and the set tightening of the bearing can be achieved.

选垫机采用工业控制机控制、自动化检测驱动桥主锥齿轮轴轴向间隙，并优化选择合适的垫片，通过垫片来消除轴向间隙并调整轴承达到设定的预紧力矩。

Parameterization Design and Fabrication for Inclined Taper Outspread Drawing

斜口圆锥展开图的参数化设计与制造

Using high class volume table, combining with the best taper equation, the individual timber's percentage of assortment table was compiled which obtained high precision and can be applied in practice.

本文利用白桦的测径样木，结合最优的削度方程，编制了白桦树高级单木材种出材率表，精度较高，可在生产实践中加以应用。

In this paper, firstly a 40Gbit/ s optical time-division multiplexer is designed and made by using the fused-tapered optical fiber coupler and the principle and influences to it are analyzed.

本文首先利用熔锥型耦合器设计并制作了一个40Gbit/s的光时分复用器，并从理论上详尽的分析了其复用原理以及各种因素对该复用器的影响。

Fused biconical taper wavelength division multiplex is one of the most important passive devices in the WDM system. It is also the most important component of WDM technology and widely used in the transmission and access network of optical fiber communication.

熔融拉锥型波分复用器是波分复用系统中重要的无源器件之一，同时也是波分复用技术中的关键组件，非常广泛的用于光纤通信的传输网和接入网中。

The final tip diameter of the fiber probe obtained from experiment was between 40~ 80nm, which was satisfied with the requirements of nondestructive measurement. And the angle of taper was at around 30 °, which might ensure the efficiency of light transmission.

实验得到的光纤探针尖端直径在40～80nm之间，符合细胞内无损测量要求，探针锥形角度大约在30°，很好地保证了光的传输效率。

Small module taper shafted straight tooth slotting cutter

小模数锥柄插齿直齿刀

The insert loss and flow loss of a reactive muffler with taper change tube were compared with that of two reactive mufflers with a straight insert tube theoretically and experimentally.

分别分析了两种不同横截面的直管内插管抗性消声器和锥形渐变内插管抗性消声器的插入损失及其流阻。

The molding size was designed according to the average shrinkage ratio of polystyrene, demoulding mechanism of taper microgroove and arc side core-pulling mechanism was used in the mold.

按聚苯乙烯的平均收缩率设计计算模具成形尺寸，在模具中设计了圆锥细纹脱模机构、弧形侧抽芯机构。

The quartz microspheres with different diameters are fabricated by melting the taper fibers with corresponding diameters using CO2 laser. The spherical microcavity coupling system is constructed with taper fiber and the quartz microsphere.

通过CO2激光器熔融不同直径的熔锥光纤以得到相应直径的石英玻璃微球，利用此微球和熔锥光纤，构造了球微腔耦合系统。

Equal spiral angle taper cylindrical milling cutter

等螺旋角锥度柱铣刀

Standpipes are big water tanks. Theoretical Analysis of Chip Flute of Spiral Taper Milling Cutter with An Equal Helical Angle

等螺旋角锥形立铣刀容屑槽槽形的理论分析