temperature loss的例句大全

In contrast with the traditional construction process where proposed double-layer paving technology has increased bond performance, optimize the structure, reducing temperature loss and reduce the layer disposal measures and so on.

在与传统施工工艺对比的情况下提出了双层摊铺技术具有提高层间粘结性能、优化结构层厚度、减少温度散失和减少层间处置措施等优点。

Using injection of impurity with higher charge of the nuclei allows us to increase the radiation cooling on a 3? ms time scale and the electronic temperature loss contract is 80% before current terminates.

用激光吹气注入高Z杂质能够增加辐射冷却，等离子体在-3ms时间内迅速冷却而且在电流终止之前电子温度损失约80%。

The outer sides of the electric heating wires are additionally provided with heat-proof and heat-insulation cloth to prevent temperature loss.

电热丝的外侧增设有耐热保温布，以防止温度的损失。

Measures to reduce the temperature loss of intermediate billet of conventional hot strip rolling mill

常规热带钢轧机减少中间带坯温差的措施

Evidences for the loss of resistance of potato to mosaic viruses under the influence of soil temperature in relation to degeneration of seed tubers

马铃薯在温度条件影响下对花叶病毒抵抗力的改变与种薯退化关系的证据

A way of "sectional matching" is thus suggested to minimize the loss of available energy due to heat transfer temperature drop.

为此建议了一种分段匹配方式，以减少由于传热温差引起的可用能损失。

To study the PEMFC's ohmic internal resistance can predict the membrane's dryness. To control the operating temperature and the cathode humidity can reduce PEMFC's ohmic loss and improve PEMFC's efficiency.

合理控制工作温度、空气湿度等参数，可以减少欧姆极化损失，提高PEMFC的工作效率。

As the requirement for freshness is especially high, more attention should be played to the fluctuation of air temperature and loss on refrigeration, apart from air content.

气调库因为对水果的保鲜要求很高，除了对气体成分控制外，还需要注意温度场的波动和水果的干耗，这两点对于气调库是至关重要的。

The pressure loss and separation efficiency under various temperature conditions of cyclones has been numerically studied.

对不同温度条件下旋风分离器的压力损失和分离效率进行了数值研究。

In some temperature interval, the weight loss rate increases when the heating rate increases.

在一定升温速率范围内，失重率随升温速率的增大而增大，反应的起始温度和终止温度也相应地向高温方向移动。

The higher content of the polystyrene ( PS) segments, the higher temperature of loss factor tan δ peak and its flowing.

SIS的硬段聚苯乙烯含量越高，损耗因子（tanδ）峰值温度和粘流温度越高。

With the switch frequency IGBT switching device input impedance high, high, high temperature extremes, driving circuit is simple, driving power small, components such as small loss more than the advantages, is extremely ideal switch components.

IGBT开关器件具有开关频率高、输入阻抗高、极限温度高、驱动电路简单、驱动功率小、元件损耗小等多个优点，是极为理想的开关元件。

Control high temperature water loss;

控制高温失水；

The suction pressure drop loss, discharge pressure drop loss, suction temperature increase loss, and mass flow leak loss were analyzed quantitatively.

分析比较了四通换向阀的吸气压降损失、排气压降损失、吸气温升损失和泄漏损失；

Based on the aging loss calculation, the limited value of temperature rise for F class insulation transformer on rated operating condition is derived. This value is satisfied with the desire of standard load system of duty class ⅴ and ⅵ.

通过寿命损耗计算，得出了F级绝缘变压器在Ⅴ级和Ⅵ级负载标准工作制条件下额定运行的温升限值。

The novel high temperature fluid loss additive named KCS-53 with functions of anti-caving and salt resistance is produced from humic acid by synthesis.

以腐植酸为主要原料。通过缩合、接枝共聚、金属离子螯合和磺化等系列反应制得了高温抗盐防塌降滤失剂K CS-53。

But the sum of temperature differences loss would increase, so that the effective heat transfer temperature differences, and at the same time, it will increase the equipment investment.

但效数增加，各效的传热温差损失的总和也将增加，致使有效的传热温差减少，同时设备投资也相应增加，15效是较为适宜的方案。

Discussion on Role of Enclosed Bus and Measures of Reduced Temperature and Loss for Outgoing Line of Large Generator Technology Research on 1000 MW Forced Air-Cooling Enclosed Bus

大容量发电机出线封闭母线的作用与降温降耗措施探讨1000MW强迫风冷封闭母线技术设计研究

It is shown that the glass-melting temperature, the homogenizing time, and the water content in the environment during the glass-melting and the fiber-drawing process are very important technological parameters in order to reduce the scattering loss.

结果表明，选择适当的熔化温度和均化时间，玻璃熔化和光纤拉制时环境中低的水含量是制得的损耗氟锆酸盐玻璃光纤的关键；

The coefficient of heat conductivity of every parts and coefficient of the heat transfer of all boundaries in the motor is analyzed and modified. And the heat source of the motor temperature field-the loss and its distribution in the motor.

分析了电机内的各导热体的导热系数和各边界面的散热系数并予以修正，同时研究了电机内温度场的热源&电机的损耗及其分布。