temperature optimum的例句大全

The Construction of an Air Temperature Calculation Model and Its Fuzzy Optimum Seeking

气温计算模型的构造及其模糊优选

Vacuum freeze drying technology was used to desiccate immune colostrums, and the factors effected desiccation such as freezing temperature? freezing speed? thickness of sample and protective additive were also studied, finally the optimum technology condition was acquired.

利用真空冷冻干燥技术对免疫牛初乳进行冻干处理，对预冻温度、预冻速率、装液厚度、保护剂等影响冻干效果的因素进行试验研究，确定了最佳的冻干工艺参数。

The optimum conditions for the treatment of cotton poplin were as follows: silicone epoxy resin 8%, baking temperature 170 ℃, baking time 4 min.

处理棉府绸最佳工艺为：含硅环氧树脂8%，焙烘温度170℃，焙烘时间4min；

The optimum conditions of burst crisps: pH 7.0, 14% moisture content of corn before frying, deep-frying temperature of 230 ° C, fried 30s.

爆裂型香酥玉米粒优化工艺条件为：浸泡液pH7.0，水分含量14%，油炸温度230℃，油炸时间30s。

The result shows that a optimum strip ( SPCC steel) heating curve and a furnace temperature curve be gained.

结果获得了SPCC钢优化的带钢升温曲线和炉温曲线；

When Nb content was 0.014 ( mass,%), finish rolling temperature was 780 ℃ and coiling temperature was 400 ℃, retained austenite fraction, carbon contents of retained austenite, Vickers-hardness and tensile strength have the optimum combination.

铌含量为0.014%、终轧温度为780℃、卷取温度为400℃时，残余奥氏体量、残余奥氏体相中的碳含量与宏观维氏硬度和抗拉强度具有最佳组合。

The phenophase of blossoming and bear fruit of Pinus Koraiensis in Weihe district was observed from 1986 to 2005, the results showed the regularity of blossoming and bear bruit and the optimum temperature in phenological periods of blossoming and bear fruit.

对苇河林区1986年~2005年红松开花结实物候期进行观测，找出红松开花结实的变化规律，指出红松开花结实各物候期的最适温度。

Then, it makes target mixture proportion design to study on the aggregate gradation scope, optimum asphalt content of mixture, the temperature and time of curing.

然后，对确定配合比例的国产环氧沥青进行混合料目标配合比设计，确定了矿料的级配范围、混合料的最佳油石比以及高温固化温度、时间等参数。

The optimum spin nozzle diameter was designed by calculation, the optimum spinneret assembling technology, spinning temperature, spinning cooling shaping condition, pre-interlace condition, drawing technology and take up tension were discussed.

通过计算设计出可用的喷丝孔径，并摸索出适宜的组件组装工艺，纺丝温度，纺丝冷却成型条件、预网络条件、拉伸工艺、卷绕张力。

the experimental results indicated that the optimum soaking time for common sowthistle seeds was 6 h at 25 ℃, and the appropriate germination temperature was 20-25 ℃.

苦菜种子的适宜浸种时间为6h（小时），适宜催芽温度为20~25℃。

the result showed that: the de value and the content of dextrose reached 50.60% and 17.40% under the optimum conditions of saccharification temperature 55 ℃, the dose of saccharifying enzyme 3 ‰, the ratio of raw materials and water 1: 4.5 and saccharification time 180 min.

实验表明，最佳糖化条件为糖化温度55℃，加糖化酶量3‰，料水比1：4.5，糖化时间180min，可使水解度（DE值）和糖化液中还原糖含量分别达到50.60%和17.40%。

while the optimum working conditions found for saccharification are: saccharifying temperature 58 ℃, ph 4.5, saccharifying time 2.5 h, saccharifying enzyme added 0.3 g/ 100 g corn meal.

最佳糖化工艺条件为糖化温度58℃，pH值4.5，糖化时间2.5h，糖化酶的添加量0.3g/100g玉米粉。

Optimum Policy Research on Temperature and Time in Oolong tea Extraction

乌龙茶在浸提中温度和时间的最佳决策研究

By studying on the processing technology of frozen precooked mussel, the optimum parameter were confirmed, including the prescription of flavorings, the concentration of seafood sauce, the temperature and time of deep fry.

通过对冷冻调理贻贝加工工艺参数的筛选试验，确定了冷冻调理贻贝的调味料配方、浆液浓度、食用时油炸温度及油炸时间等工艺参数。

The optimum hydrolyze temperature was 55 ℃ to filter paper and 50 ℃ to absorbent cotton.

降解温度以滤纸55℃，脱脂棉50℃为最佳。

Determined Optimum Critical Value of Investment with Nuclear Heating System at Low Temperature

低温核供热系统最佳投资临界值的确定

The optimum reaction conditions of synthesizing before-mentioned two materials have also been studied, such as the kinds and dosage of monomers, the dosage of initiator and emulsifier, the kinds of emulsifiers, reaction temperature, proceeding of polymerization, and so on.

研究了合成上述两种物质的最佳反应条件，如单体的种类及用量、引发剂用量、乳化剂种类及用量、反应温度和聚合工艺等；

The optimum storage temperature of bitter melon was 13 ℃.

13℃贮藏15天苦瓜没有发生冷害，13℃是苦瓜的适宜贮藏温度。

Study on the Optimum Storage Temperature of Bitter Melon

苦瓜适宜贮藏温度的研究

The optimum temperature for the flower bud differentiation was 20 ℃.

花芽分化的最适宜温度为20℃。