tensile load的例句大全

A Biomechanical Study on the Compression and Tensile Load on Skull of Mayfield Head Holder in Cervical Posterior Approach

颈椎后路手术Mayfield头架固定颅骨耐受压力和拉力的实验研究

Study on constitutive model and permeable coefficient tensor of rock under tensile load with micromechanics ( I): Anisotropic constitutive model

拉应力条件下岩石细观力学本构模型和渗透系数张量研究（I）：各向异性损伤本构模型

Effect of a Laser Discrete Pre-quenched Substrate on the Fracture Behavior of Chromium Coating/ 45 Steel Substrate under Tensile Load

拉伸载荷作用下基体表层激光离散预处理对铬镀层/45钢基开裂行为的影响

Molecular Dynamics Simulations of "Y"-Shaped, Bamboo-Shaped, and Straight Carbon Nanotubes Under Tensile Load

Y型、竹节型与直纳米碳管的力学特性研究

The ultimate tensile load of the 3D braid increases significantly by incorporating PGA fibers into the braiding yarn.

在编织纱中掺入PGA纤维，可显著提高三维编织物的最大拉伸裁荷；

The failure mechanism and mechanical property of a brittle composite matrix, reinforced with short fibers under the uniaxial tensile load, have been studied.

研究短纤维增强脆性基复合材料在单轴拉伸荷载下的力学性能和破裂机理。

the results of test for 08b double-strand roller chain indicate that the best preload is about 2/ 3q ( q is the ultimate tensile load of the tested chain) and it improves the fatigue performance and length accuracy uniformity obviously.

对08B双排链的试验结果表明，经（2/3）Q（Q为链条极限拉伸载荷）预拉后的链条、链长精度均匀性明显改善；

The displacement fields and stress fields of 3-d braided composites are gained at tensile load by using ANSYS which their reinforced mechanics are proved;

应用ANSYS模拟得到了三维编织复合材料在承受拉伸载荷时的位移场和应力场，验证了编织复合材料的增强机理；

This paper describes that the failure tensile load and deformation were tested by the specimens which were made from carbon-fiber fabrics and epoxy resin.

本文把单向碳纤维无捻布和环氧树脂制成复合材料试样，测试出其拉伸破坏载荷和变形；

The lap joint produces bending effect under the action of tensile load and the bending degree decreases with the increase of yield limit of base material.

搭接接头在拉伸载荷作用下会产生折弯效应，折弯程度随被钎焊母材屈服极限的增加而减小。

A Class of Coupled Nonlinear System of Hyperbolic Equations Analysis on Load-transfer Characters of Uplift Piles under Tensile Loading Based on Hyperbolic Model

基于双曲线模型的抗拔桩荷载传递分析方法研究

Radial interference fit ( 0.1 mm)-336 MPa axile tensile load.

径向过盈配合0.1mm，轴向拉伸载荷336MPa。

The splitting tensile load-displacement curve acquired from an improved technology can perfectly describe the toughened effect of steel fiber.

劈拉荷载&位移曲线可以较好的描述纤维的增韧效果。

The result showed that the tensile load near the crack tip was dominant, and the tensile load had higher effect than the shear load.

结果表明，拉伸载荷主导界面裂纹尖端附近区域，并且拉伸效果远大于剪切效果。

Thanks to tensile membrane action, the actual load capacity was much grater than the design capacity using yield-line theory.

由于受拉薄膜效应的存在，混凝土板的实际承载力比按塑性铰线理论的计算结果高得多。

At the test temperature, the maximum compressive strain, the maximum tensile strain and strain amplitude are all in exponential relationship with the axle load.

在试验温度下，最大压应变、最大拉应变和应变幅值均随轴载的增加呈指数关系增大。

These outside conditions include environmental temperature, voltage, tensile stress, and bending load.

这些外部环境因素包括:环境温度, 外加电压, 拉伸应力, 弯曲荷载.

The polypropylene fiber concrete has excellent tensile performance, crack resist-ance, ductility and load-carrying capacity and especially the polypropylene fibers can contribute to good control of early cracking in the surface of concrete.

聚丙烯纤维混凝土具有优良的抗拉性能、抗裂度、韧性和承载力，特别是对水泥混凝土表面的早期开裂控制起到了良好的作用。

The methods of creep test to get both curves of tensile creep rupture load vs time and creep strain vs time are compared. The procedures to extrapolate the two types of creep curves are presented.

比较了获得拉伸蠕变破坏荷载-时间曲线以及蠕变应变-时间曲线的试验方法，给出了外推这两种蠕变曲线数据的处理步骤。

According to the analysis of experimental data, based on the theoretical model of composite, we can get a theoretical tensile curve of specimen and the theoretical deflection curves on 3-point bending load bending, then compared them with experimental data respectively.

分析实验数据，并根据复合材料理论分析模型，得出试件理论拉伸曲线和三点弯曲载荷下的理论挠曲线，分别与实验数据进行比较。