tension test的例句大全

Application of Proportional Relief Valve in Hydraulic Loading System of Tension Bearing Test Equipment

比例溢流阀在轴承试验液压加载系统中的应用

Test method for tension& tension fatigue of fiber reinforced plastic laminates

GB/T16779-1997纤维增强塑料层合板拉-拉疲劳性能试验方法

Test of Tension in Chains of En Mass Conveyor

埋刮板输送机刮板链条张力测试

Basic Principle and equipment of tension annealing and levelling are briefly introduced. The test results of its application on AgCu/ QSn composite tape are presented.

简要介绍了张力退火矫直的基本原理、设备及对AgCu/QSn复合带进行张力退火矫直的试验结果。

Through a lot of experiments and analysis, it was pointed out that the twist number of steel wire in torsion test decreased gradually with increasing axial tension load.

本文通过大量的试验和分析，得出钢丝扭转试验时，随着轴向拉力负荷的增加，其扭转次数趋于递减的变化过程。

Exhaust of antifoaming performance of modified products is related with particle size of modified product become bigger during the course of test, also related with the change of surface tension of foaming medium before and after the breaking foam performance test.

改性产物的性能衰减与其在消泡过程中粒径变大和分散状态以及起泡介质表面张力升高等因素有关。

Finally, by employing mechanical properties test, it shows that the tension strength, elastic modulus and micro-hardness of Mg-Ti alloys have increased evidently with joining Ti due to the high tension strength and melting point as well as high elastic modulus of Ti.

通过对Mg-Ti合金进行力学性能测试表明，在Mg中加入高强度、高熔点、高弹性模量的Ti，显著提高了材料的抗拉强度、弹性模量和显微硬度，且它们随着Ti含量的增加而增加。

Analysis of Static Load Test of Tension Pile Bored in Permanently Frozen Ground

多年冻土地区钻孔灌注抗拔桩静载试验分析

Performance test and application of electrostatic precipitator of superhigh tension and wide pole pitch

超高压宽极距电收尘器的性能试验与应用

Centrifugal model test study on tension of CAT reinforcement in reinforced earth retaining wall of three steps

三级加筋土挡墙CAT拉筋的离心模型试验研究

In the laboratory test with single rolling stand simulate the continuous tube rolling process with front tension and thrust rolling diagram to determine various parameters of tension and thrust force, rolling pressure and deformation.

在实验机组上用单机轧制模拟连轧管机带张推力的轧制图示，对张推力、轧制力、变形参数进行了测定。

The stress corrosion behavior of 304 stainless steel in the solution saturated by H2S and the standard solution of NACE was studied with electrochemical test and slow strain rate tension ( SSRT) test.

用电化学测试及慢应变速率拉伸试验（SSRT）方法对304不锈钢在饱和H2S溶液和NACE标准溶液中的应力腐蚀行为进行研究。

It is shown that both the predicted fatigue life and the test results of fatigue life of notched elementals of 45 carbon steel under tension tension variable amplitude loading follow the log normal distribution, and the two distributions agree well with each other.

结果表明：45钢缺口件在多级拉拉变幅载荷下的疲劳寿命和累积疲劳损伤临界值的预测值与试验值均近似服从对数正态分布，且两者符合很好。

Improvement and test to the apparatus of liquid saturation vapor tension

液体饱和蒸气压测定装置的改进与实验

The principle of portable test and measurement instrument for cable tension, and the design and technology features of software and hardwares of this instrument are presented

介绍了便携式缆索张力测定仪的测力原理及软硬件设计和技术特性

Using infrared imaging instrument, the process of tension press and lower cycle fatigue is measured continuously for plate test piece of metal. Further the measured results are processed numerically and the numerical response of dynamic temperature fetid on the surface of measured piece is obtained.

利用红外热象仪连续测量金属板试样的拉压低周疲劳过程，将测量结果进行数值化处理得到被测试样表面动态温度场的数值响应。

A method to solve tension softening relationship of concrete obtained a three-point bending test is presented.

确立了分别基于开裂强度准则和断裂韧性准则的由三点弯曲实验确定混凝土材料抗拉软化关系的方法.

Tension eccentricity of the specimen section is the main problem in concrete homogenous tensile strength test.

试件截面受拉偏心是混凝土均匀受拉强度试验中存在的主要问题。

When the sensor is used to test steel bar after it has been calibrated, the accuracy of the sensor is better than ± 2.5% for the tension strain and ± 2.9% for the compression strain.

定标后传感器测量钢筋拉应变时，其应变的精度优于±2.5%；测量混凝土压应变时，其精度优于±2.9%。

Base on the test of reinforced membrane elements and regression analyses, the formulas of tension strain produced compressive stress are presented respectively before crazing of concrete, before yield of steel bars, and tensile strain less than 0.008 and greater than 0.008 in this paper.

文章基于钢筋混凝土薄膜元受拉试验和回归分析，给出混凝土开裂前、钢筋屈服前、拉应变小于0.008和大于0.008时的应力应变关系式。