thermal intensity的例句大全

PL spectra and Thermal gravimetric analysis ( TGA) showed that the flakes and flowers have narrow PL peak widths and lower intensity than that of powder, which is likely caused by the solvents quenching.

其荧光光谱和热重分析表明，微米片状和花状结晶态的荧光峰宽较粉末窄，单色性较好，其荧光强度较弱，可能是由存在9.7wt%溶剂所致。

Thermal History and Secondary Hydrocarbon Generation Intensity of Marine Source Rocks in Lower Yangtze Area

下扬子地区热历史与海相烃源岩二次生烃潜力

Transient thermal stress intensity factors for a functionally gradient material with symmetrical structure

对称型梯度功能材料的瞬态热应力强度因子

With the material technology improved and non-Fourier effect more widely applied, it is very necessary to research the thermal stress intensity.

所以，随着材料技术的提高以及非傅里叶效应越来越广泛的应用，针对热应力强度的研究是非常必要的。

The concept of thermal stress intensity factors in a current-carrying plate with two same penetrated collinear cracks was built in this article.

文中建立带有两个等长度共线穿透裂纹载流薄板的热应力强度因子的概念。

Satellite infrared brightness temperature is calculated according to the black body radiation law using the object thermal radiation intensity data collected and recorded by on-board sensors.

卫星红外亮温是利用星载传感器收集、记录地物的热辐射强度数据，根据黑体辐射的定律计算得到的亮度温度。

By using the numerical Laplace inversion method, the variations of the temperature distribution along the crack surface and extended line and transient thermal stress intensity factors are presented.

利用Laplace数值反演方法，给出了裂纹面及延长线上的温度分布及动态热应力强度因子随时间变化的规律。

The results show that under the same condition, the thermal radiation intensity of the complex is higher than that of the opal quartz by over 10%.

与乳白石英玻璃相比较，在相同的条件下，其热辐射强度可提高10%以上。

Can remove the TAB fungus in the concentration fruit juice, reduces the thermal sterilization intensity, simultaneously enhances each physics and chemistry target.

可去除浓缩果汁中的TAB菌，减少果汁热力杀菌的强度，同时提高果汁的各项理化指标。

At higher thermal radiation intensity, all samples produced the heat release rate and peaks have increased, the total heat release increased, mass loss increased, but the effective heat of combustion is about the same.

在较高的热辐射强度下，所有的试件产生的热释放速率及其峰值都有所增加，总放热量增大，质量损失增多，但有效燃烧热都相差不大。

The example showed that the value of thermal stress intensity factors near the crack tips caused by point heat source was minus and this could counteract parts of stress intensity factors intension caused by tension loaded in distance and the crack extension could be arrested.

算例分析表明，点热源在裂纹尖端附近产生的热应力强度因子为负值，可以部分抵消无穷远处施加的拉应力产生的应力强度因子的作用，进而达到止裂的目的。

The results show that the thermal stability and machine intensity were improved compared to Polyvinylidene Fluoride membrane.

结果表明，与聚偏氟乙烯膜相比，改性膜的热稳定性和机械强度均有所提高。

Density, porosity, thermal expansion coefficient and intensity were tested by Archimedes-method, show the distance and bend resist of three point etc.

用示差法、阿基米德法、三点弯曲法等方法测试出材料的热膨胀系数、密度、吸水率、气孔率、强度等。

The gravitational thermal analysis, machine intensity analysis and contact angle determination were employed to characterize the performance of Polyvinylidene Fluoride membrane after hydrophilic modification.

用热重分析、机械强度分析和接触角测定对亲水改性后的聚偏氟乙烯膜进行了表面性能表征。

The thermal quenching of PL intensity for samples annealed at 900 ℃ measured at temperatures from 15K to 300K is 30%.

测量温度从15K变化到300K时，样品（900℃，30min退火的GaN：Er）的1540nm处PL温度猝灭为30%。

Thus formed TiC during crystallization can increase the hardness, ( wearability,) thermal resistance and high-temperature intensity of bead welding metal, which can greatly lower the cost of bead welding rod.

可见，在结晶过程中形成的TiC提高了堆焊金属的硬度、耐磨性、耐热性和高温强度，可大大地降低堆焊焊条的成本。

Objective: ( 1) To observe the number changes and distribution of tumor-infiltrating lymphocytes ( TIL) in treated tumor after in situ thermal ablation of high intensity focused ultrasound ( HIFU) for patients with breast cancer.

目的：（1）观察乳腺癌患者HIFU后局部肿瘤浸润淋巴细胞（TIL）的浸润分布特点及活化分子表达。

The experimental results show that there is a higher heat transfer intensity of the thermal interaction between droplets and hot surface heated over the transition temperature of Leidenfrost Phenomena.

试验结果显示，液滴撞击温度超过转变温度的金属板面时具有很高的传热速率。

Thermal behavior for interaction of high intensity energetic beams with surface of material

强流载能束与材料表面相互作用的热效应

In Xi'an City thermal inversion might occur in four seasons of a year, but its frequency was the highest in winter. Annual mean intensity of inversion was 0.90 ℃·( 100m)~ (-1).

西安市一年四季都有逆温存在，100m平均逆温强度为0.90℃；