thickness的例句大全

The thickness of Al films was correlated with bias voltage, deposition time, Al target current, and the substrates' conductivity.

铝膜厚度与偏转电压、沉积时间、Al靶电流以及基底材料的导电性能等PVD处理参数相关；

During the stage of a rapidly increasing temperature, four main factors ( MC, the temperature of hot-plates, target density and thickness) affect temperature and gas changes, and gas pressure of core is ascending;

快速升温段：四个主要因素（热压温度、含水率、目标密度和目标厚度）对温度和气压的变化有着一定的影响，中心气压是上升的；

Effects of Fiber Board Target Thickness and Density on Vertical Density Profile

纤维板目标厚度和目标密度对剖面密度分布的影响

According to the experimental data, the effects of steam pressure, target thickness, target density, temperature and moisture content of mat on the time were evaluated. Some basic laws of steam-injection hot-pressing heat and matter conduction of middle and low density fiberboard were summarized.

分析蒸汽压力、目标厚度、目标密度、热压温度及板坯含水率对其影响，得出了中低密度纤维板喷蒸热压传热传质的基本规律。

Thickness Target Function Method for Load Distribution During Hot Strip Rolling

热轧带钢负荷分配目标厚度函数法

Some different thickness aluminum reflective films were produced on silicon substrate by using the electron-beam evaporation method and high purity aluminum target. The reflectivity curves of Al film in the visible light region were measured, the density and conductivity of films were analyzed.

采用电子束蒸发的方法，以高纯度的Al为靶材，硅片为衬底，制备了不同厚度的Al反射膜，并测量了在可见光范围内反射率曲线，分析了薄膜的致密性和电导率。

Results indicate that the ballistic performance, in terms of differential efficiency factor Δ e c and Tate target resistance R t, decreases with increasing ceramic thickness and cover plates can enhance the ballistic performance.

实验表明：随陶瓷厚度的增加，以差分效益系数和靶平均阻力表征的陶瓷复合靶的抗长杆弹侵彻性能降低；

Research for the relations between residual speed and target thickness

剩余速度与靶板厚度关系的研究

The intensity of transition radiation decreases with the increase of target thickness.

光发射光强随靶厚度的增加而减小。

The Optimization Analysis and Design of Gas Target Thickness of HT-7 Neutral Beam Injection System

HT-7中性束注入器气体靶厚度优化分析与设计

Application of amplitude tuning in surveying geologic target thickness less than 1/ 4 wavelength

应用振幅的调谐作用探测地层厚度小于1/4波长地质目标

The results show that the saturation activity increases with increases of the electron beam energy and the tungsten target thickness.

结果表明，随钨靶厚度及入射电子束能量的增加，As增加。

The molecular effect [ R ( Yf)] in the forward electron emission decreases with target thickness at a certain energy.

前向发射产额的分子效应R（Yf），在给定的能量下随靶厚增加而下降。

The effect of projectile density, shapes, target thickness, projectile diameter, impact velocity and angles etc. on crater has been investigated.

研究了弹丸密度、弹丸形状、板厚度、弹丸速度、弹丸直径和弹丸撞击入射角等对靶成坑的影响。

Both types of the laser thermal stress time curves become complicated with the decrease of the target thickness or with the increase of laser intensity irradiated on the target surface.

两者的激光热应力－时间曲线随靶厚的减薄或随辐照靶面激光强度的增加而变得越来越复杂。

The effects of target thickness on emission directions of hot electrons are investigated in the interaction of subrelativistic intensity laser pulses with foil targets.

研究了近相对论强度的激光脉冲与薄膜靶相互作用中，靶厚度对超热电子发射方向的影响。

This paper introduces the methods of target thickness and uniformity measurements including weighing, a-particle thickness gauge, quartz thickness gauge, optical transmittance and Rutherford backscattering.

本文系统地介绍了核靶厚度和均匀性的测量方法，包括天平称重法、石英晶体测厚法，等效空气α粒子能量损失法，吸光光度法和离子背散射法。

The article primary introduces composing of HT-7 Neutral Beam Injection ( NBI) system, then mainly analyzes gas target thickness, that is pressure distribution of neutralizer gas cell, one of factors which affect heating efficiency of NBI.

本文首先介绍了HT-7中性束注入（NBI）加热系统的组成，然后对影响中性束注入加热效率因素之一的气体靶厚度即中性化室的压力分布进行了重点分析。

The results show that for the given laser flux and target thickness, the spallation is possible only for the laser pulse duration within a certain range and, furthermore, the lowest laser flux for spallation corresponds to the optimum laser pulse duration.

本文结果指出，对于一定的激光通量和靶板厚度，只有一定范围内的激光脉宽才能造成层裂，最低激光通量则对应于最佳激光脉宽。

By changing target board thickness, the residual speed was measured after the tungsten alloy 105 simulative penetrator penetrated 45# steel with different thickness at the same speed.

采用改变靶板厚度的方法，测量了约在相同速度的条件下钨合金105模拟穿甲弹侵彻不同厚度45钢板后的剩余速度。