working temperature的例句大全

The draught fan comprises a two-speed motor of resisting high temperature and high humidity working environment.

它包括一耐高温高湿工作环境的双速电机；

A small diameter rolling pillar is equipped on the working platform of traditional line erecting car with "low temperature and high platform" for supporting contact wire and making it turning during the construction of line erecting.

我国铁路电气化架线施工中，在传统钓低盘高台式架线车的作业平台上，设置的是一根小直径滚柱来支承接触线并使其转向。

When the power equipment cabinet is working, there will be a large current flowing through the copper bar of the power equipment cabinet. It will definitely brings a great increase in temperature.

当电源机柜工作时，会有较大的电流流过电源机柜的端子座，这必然会带来极大的温升。

A natured safety type multifunctional hydraulic sensor used in coal mine was developed for the dynamic test of shearer's hydraulic systems pressure, flow and temperature in the shearer's working state monitoring system.

在采煤机工况监测系统中为动态测试采煤机液压系统的压力、流量和温度、研制了矿用本质安全型液压多功能传感器。

This paper presents a type of insertion smart sensor with low power for measuring temperature& moisture content of grain and it's working mechanism, structure and functions.

本文介绍一种用于粮食温度、水分检测的低功耗插杆式智能传感器，论述了传感器的工作机理、结构和功能特点。

It has strong absorb power, low working noise, no leakage and temperature rising.

吸人能力强，工作噪声小，无泄漏，无温升。

First Inquiring into Test and Technical Conditions of Continous Working at High Temperature

汽车点火电子组件高温连续工作试验技术条件初探

After thermo-electronic analogy is discussed, current heat dissipation components are simulated and tested with the multiplex temperature measurement platform, and working states of the natural cooling and forced cooling are compared and studied together.

在热路分析理论即热电模拟的基础上，借助多路温度测试平台完成对通用散热器件的模拟散热试验，比较了在不同工况下的散热器的工作情况，并加以对比研究，同时计算热阻验证。

the problem of oscillation of temperature field numerical solution of blast furnace gas and stock temperature field is solved by the upwind finite element analysis, and the working conditions of blast furnace with the center coke charging is analyzed.

将迎风有限元法引入高炉煤气和炉料温度场解析，解决了强对流条件下温度场数值解的失真振荡问题，分析了中心装焦时的高炉炉况。

reason analysis and improvement of high working oil temperature of hydraulic coupling in induced draft fan and pipe vibration

引风机液力偶合器工作油温高和管路振动原因分析及治理

evaluations of three different types of temperature measurement system have been made. especially a newly developing jw-11 type infrared coke cake temperature measurement system, its working principles, system organization and results of practical tests are described in detail.

对试验过的3种红外测温系统进行评价，重点叙述了JW-11焦饼红外测温系统的测温原理、系统组成和现场试验情况。

maximum working pressure and super heated steam temperature of stationary steamboilers

陆地安装的蒸汽锅炉最高工作压力和过热蒸汽温度

In order to suppress the heat effect of blue laser using planoconcave cavity when working, use Thermal Energy Converter ( TEC) to control the temperature of gain medium Nd: YAG crystal and SHG ( Second Harmonic Generation) LBO crystal.

为了解决平凹腔蓝光固体激光器晶体在工作中因热效应问题产生的影响，针对激光的增益介质Nd：YAG晶体和用以倍频的LBO晶体，采用半导体制冷器（TEC）准确控制其工作时的温度。

Principles of diode-pumped solid lasers and ideas of design of DPSL working under wide temperature range are described.

介绍了半导体泵浦固体激光器工作原理以及宽温度范围条件下的设计思想。

Diode-end-pumped CW Tm, Ho: YLF solid-state laser working at room temperature

激光二极管端面抽运室温Tm，Ho：YLF连续固体激光器

acid and frac treatment is one important measure for hydrocarbon reservoir to increase production, the performance of acid and frac working liquid and acidizing fluid additive directly affect the effect of acid and frac treatment, especially for deep wells with high temperature and low permeability.

酸压是油气藏重要的增产措施之一，酸压工作液及酸液添加剂的性能直接影响酸化效果，对低渗透、高温深井尤为突出。

owing to the high temperature in electric arc furnace, excessive dust and abominable working condition, the composition and temperature can not be measured directly.

由于电弧炉炉温高、粉尘大、冶炼条件恶劣，电弧炉炉内的温度和熔池参数不宜直接连续检测。

The temperature distribution inside the porous medium combustor and the levels of NO and CO emissions are measured at various working parameters.

在各种工况参数下，对多孔介质内轴向温度分布以及NO、CO和CO2气体等污染物排放的浓度进行了系统测量。

Pressure and temperature in the PM engine are calculated under various working conditions. Influences of operating parameters such as compression ratio, equivalence ratio, temperature and volumetric heat transfer coefficient of the porous medium on combustion process of the PM engine are analyzed.

计算了多种工况参数下PM发动机缸内温度、压强变化规律，分别讨论了压缩比、过量空气系数、多孔介质温度、多孔介质体换热系数等参数对多孔介质发动机燃烧过程的影响。

thermal analysis of rankine cycle at moderate and low temperature and the selection of working liquids

中、低温朗肯循环的热力分析与工质选择