sliding speed

The effect of microscopic parameters on slope stability, sliding speed and sliding distance was discussed.

讨论了各细观参数对边坡稳定以及滑体的滑行速度、滑行距离等因素的影响。

Friction and Wear Behavior of Graphite Partiele/ Al Composites at High Sliding Speed and High Temperature

铝/石墨复合材料高速高温下的摩擦磨损特性

With the increase of the sliding speed and the normal load and with the prolonged sliding time, the surface temperature was elevated.

干摩擦时3Y-TZP表面温度随速度和载荷的增大而升高，且随滑动时间的延长而升高。

The friction coefficient becomes smaller as the loads and sliding speed becomes larger, but the wear rate is reversed.

摩擦系数随着载荷和滑动速度的增大而减小，而磨损率则随它们的增大而增大。

The effects of sliding speed and load were considered.

分别考察了滑动速度和载荷对两种材料的摩擦因数以及磨损量的影响。

A dynamical-integral sliding mode control approach was proposed for the speed controlling of AC servo system.

针对交流伺服系统速度控制问题,提出了一种动态积分滑模控制方法.

The experimental results indicate that with increasing of contact pressure the rate of wear of materials increases and with increasing of sliding speed the rate decreases.

结果表明，随接触压力的增加，材料的磨损率增加；随摩擦速度的增加，材料的磨损率减小。

When the normal load and the sliding speed increased, the friction coefficient decreases.

随着法向载荷和滑行速度的增大，摩擦因数减小。

The changes of load and sliding speed will lead to the variety of friction coefficient.

载荷和相对滑动速度改变时，摩擦系数也相应改变。

Investigation on the relationship between sliding speed and soil-metal friction

金属-土壤摩擦阻力与滑动速度关系的研究

This indicates that as the sliding speed increases the effects of water lubrication and load carrying capacity of the friction pair are improved.

说明滑行速度提高时，水润滑效果会更加明显，且摩擦副具有较高的承载能力。

At low normal load and sliding speed, the main wear mechanism of 3Y-TZP is plastic deformation.

在低载低速下3Y-TZP陶瓷的主要磨损机制为塑性变形；

And the wear rate increases with theimproving of sliding speed.

而磨损率随着滑动速度的提高而增大。

Based on the above results, the calculating formulae of the induced normal curvatures and the angles between the contacting line and direction of the relative sliding speed are introduced.

以上述工作为基础，进而导出了行星轮轮齿滚珠与定子螺旋面及转子蜗杆之间的接触线上诱导法曲率以及接触线与相对速度之间夹角计算公式。

BGB is not sensitive to sliding speed and water pressure, so it can suit various situations of facing.

同时这种垫层材料对面板滑移速度和水压力大小均不敏感，这对于适应面板在各种情况下的滑移十分有利。

Sliding speed is key to the design of strop ropeway.

滑速是滑索设计的关键。

An Experimental Study of the Relation between Friction Force and Relative Sliding Speed

摩擦力-相对滑动速度关系的实验研究

With the increase of sliding speed, stability of friction decreased and stability of current collection became worse.

随着滑动速度的增加，摩擦稳定性降低，受流稳定性变差。

Wear rate showing an increasing trend with increasing sliding speed and contact current.

磨耗率随着滑动速度和接触电流的增大呈现增大的趋势。

Failure analysis on excess wear of sliding bearing of pluse stepless speed change device

脉动无级变速器滑动轴承磨损失效分析

The effects of different sliding speed of magnetic field on friction and wear effects.

研究了不同滑动速度下磁场对摩擦磨损的影响。

The results show that, the friction coefficients vary with normal pressure, sliding speed and temperature.

实验结果表明：随着正压力、滑动速度和温度的变化，闸瓦材料摩擦因数均发生变化；

Influence of Sliding Speed on Wear Resistance of Nano-Particles Composite Coating

滑动速度对纳米颗粒复合镀层摩擦性能的影响

Traction characteristics of synthetic lubricants at high sliding speed contacts

大滑速下合成润滑油的摩擦牵引力研究

The results show that the wear rates of the two materials increase and the friction coefficients decrease with increasing of normal load and sliding speed.

结果表明，两种材料的磨损速度随载荷、滑动速度增大而增大，磨擦系数随之降低。

The friction can be calculated according to the sliding speed, the oil film between the two contact surfaces by using the model.

该模型可以根据滑动速度、表面接触物体的油膜厚度等计算摩擦力。

Higher sliding speed leads to stronger thermal effects.

轮轨的相对滑动速度越高，其热效应越明显。

When the sliding speed and contacting pressure were increased, the friction and wear mechanism would be changed.

在逐步增加速度与载荷的过程中，存在着摩擦磨损机制的改变。

The increase of sliding speed does not affect the depth of phase transformation zone, but increase the probability of phase transformation.

滑行速度的提高可以增大相变层出现的几率，但并未增加相变层的深度；

The effect of sliding posture and power on speed skating performance

滑行姿势和功率对速滑成绩的影响