sliding speed的例句大全

The effects of different sliding speed of magnetic field on friction and wear effects.

研究了不同滑动速度下磁场对摩擦磨损的影响。

Investigation on the relationship between sliding speed and soil-metal friction

金属-土壤摩擦阻力与滑动速度关系的研究

The experimental results indicate that with increasing of contact pressure the rate of wear of materials increases and with increasing of sliding speed the rate decreases.

结果表明，随接触压力的增加，材料的磨损率增加；随摩擦速度的增加，材料的磨损率减小。

Higher sliding speed leads to stronger thermal effects.

轮轨的相对滑动速度越高，其热效应越明显。

The changes of load and sliding speed will lead to the variety of friction coefficient.

载荷和相对滑动速度改变时，摩擦系数也相应改变。

And the wear rate increases with theimproving of sliding speed.

而磨损率随着滑动速度的提高而增大。

The effects of sliding speed and load were considered.

分别考察了滑动速度和载荷对两种材料的摩擦因数以及磨损量的影响。

The results show that at low sliding speed and small load, the main dry sliding wear mechanism of the coating is oxidation wear, and the wear resistance of the coating is 2~ 4 times higher than that of tempered 45 steel.

结果表明，轻载低速条件下，熔涂层的干摩擦滑动磨损机制以氧化磨损为主，与淬火低温回火态45钢相比，熔涂层的耐磨性是45钢的2～4倍；

An Experimental Study of the Relation between Friction Force and Relative Sliding Speed

摩擦力-相对滑动速度关系的实验研究

Influence of Sliding Speed on Wear Resistance of Nano-Particles Composite Coating

滑动速度对纳米颗粒复合镀层摩擦性能的影响

Wear rate showing an increasing trend with increasing sliding speed and contact current.

磨耗率随着滑动速度和接触电流的增大呈现增大的趋势。

When the normal load and the sliding speed increased, the friction coefficient decreases.

随着法向载荷和滑行速度的增大，摩擦因数减小。

The effect of microscopic parameters on slope stability, sliding speed and sliding distance was discussed.

讨论了各细观参数对边坡稳定以及滑体的滑行速度、滑行距离等因素的影响。

The results show that, the friction coefficients vary with normal pressure, sliding speed and temperature.

实验结果表明：随着正压力、滑动速度和温度的变化，闸瓦材料摩擦因数均发生变化；

The effect of surface phase constitution, surface roughness, sliding speed, press force and anti-rust oil on friction coefficient of galvannealed IF sheet steel has been tested and researched.

采用平板滑动实验研究了表面相组成、表面粗糙度、拉速、压力及涂油品种等因素对汽车用合金化热镀锌IF钢表面摩擦系数的影响。

Sliding speed is key to the design of strop ropeway.

滑速是滑索设计的关键。

The wear characteristics of polytetrafluoroethylene ( PTFE) were tested on the model MPX-200 pin-on-disk tester in this paper. The effects of sliding speed, load, temperature and surface roughness of counterparts on wear were determined.

作者用MPX-200型栓-盘摩擦磨损试验机测试了模压聚四氟乙烯的磨损性能，考察了滑动速度、负菏、温度及偶件表面粗糙度对磨损的影响。

The plastic deformation is accelerated at high sliding speed and normal load, which is accompanied by localized melting on the worn surfaces of the frictional materials.

在高速和高压条件下塑性变形加剧，摩擦材料磨损表面可见熔融迹象；

Wear rate of Si_3N_4 ceramic rose with the increase of loads between Si_3N_4 ceramic and chilled iron while the effect of relative sliding speed on wear rate of Si_3N_4 ceramic is not as significant as that of load.

Si3N4陶瓷的磨损率随载荷的增大而增大，滑动速度对磨损率的影响要小于载荷对其的影响；

Traction characteristics of synthetic lubricants at high sliding speed contacts

大滑速下合成润滑油的摩擦牵引力研究