surface load

It is demonstrated that the radiation surface temperature and overall structure strength of the straps under the real thermal load ( 0.2MW) satisfy the design requirements.

论证了在实际工况热载荷条件（0.2MW）下，电流带辐射面温度及电流带整体结构强度满足设计要求。

The action between layers of asphalt concrete surface and aggregate base under load may be a contact problem in fact.

考虑荷载作用下，沥青路面面层之间以及面层与基层之间，实际上可能处于接触状态。

The Study of Bond Failure Load of Near Surface Mounted CFRP Plate to Concrete

混凝土表层嵌贴CFRP板条的极限粘结承载力分析

For inclined-tube sedimentation design, the parameter of tank can be determined by inclined-tube parameters, discharge and surface load.

对于斜板（斜管）沉淀池设计，则主要通过选定的斜板（斜管）参数、流量和表面负荷等来确定沉淀池的各参数。

ST bumper used to resist shock is a pivotal part in railway vehicle transportation. As primary load-transfer component of this part, thrust cone required very high precision and surface quality.

ST型缓冲器是铁路车辆运输过程中用于抗冲击的关键部件，推力锥作为其中的主要传力零件，其精度和表面质量要求都非常高。

A set of one-dimensional regular integral equations is derived for calculating the dynamic response of elastic layer on stiff foundation under time harmonic surface vertical concentrated load. And the numerical solution of the integral equation is obtained.

导出了刚性基础上的弹性层在表面垂直集中简谐载荷作用下动力响应问题的一维非奇异积分方程组，并求得了数值解。

Below figure shows the relation between fumace temperatures, element temperature and element surface load under the condition that the element radiation isn't obstructed.

下图示出了元件辐射在不受阻碍情况下的炉温、件温度与表面负荷之间的关系。

Then, the mathematics model of calculating the surface load and point load in the design of aircraft structure static load test using aircraft surface model is established.

其次结合飞机的曲面外形，建立了飞机结构静力试验设计中的分布式载荷和集中式载荷的演算数学模型。

The research of aerodynamical load for the lift surface of helicopter

直升机升力面气动载荷研究

Based on the established equivalent numerical analysis model of sliding plug door made from composite material and taking use of ANSYS numerical value, we simulate the response of sliding plug door of high-speed train under surface load of 6000 Pa, and validate the simulation result through experiment.

依据已建立的复合材料塞拉门数值分析等效模型，利用ANSYS数值模拟了高速列车塞拉门在6000Pa面静载荷下的响应，并通过实验对模拟结果进行了验证。

When the dipping angle of the slide surface is steep, the whole sliding will be predominant, which implies that load design could be determined by classical slice methods.

当滑动面倾角较大时，滑动效应占主导地位，抗滑桩的设计荷载可根据各种条分法来确定。

Under offset load, the stresses around the crack tip and the surface deflection in the pavement with cracks have a great increase compared with that without cracks.

在偏荷载作用下，含表面裂缝的路面结构裂缝尖端的应力以及路表弯沉较无裂缝结构有很大的增长。

Dynamic Response of Elastic Layer on Stiff Foundation under Time Harmonic Surface Vertical Concentrated Load

刚性基础上的弹性层在表面垂直集中简谐载荷作用下的动力响应

Compared to the cross-section, the surface of the coatings had better ability to resist applied load and better elastic recovery after unloading.

涂层表面比断面具有更为优良的抵抗外加负载和卸载后良好的弹性恢复的能力。