stress model的例句大全

Effect of cold-water stimulation on rat stress model of bile secretion

冷水刺激对大鼠胆汁分泌应激模型的影响

The Principle of Minimum Complementary Energy and Hybrid Stress Model

最小余能原理与杂交应力公式

A local internal stress model of tectonic earthquakes normal mode

构造地震的局部内应力源模式

Objective: To study the effect of Banxia Houpu Decoction in a chronic mild stress model of depression and investigate the antidepressive mechanism.

目的：研究半夏厚朴汤醇提物对大鼠慢性抑郁模型（CMS）的影响，探索其抗抑郁机制。

Tectonic stress field quantitative model and petroleum distribution in low-order complex fault blocks

低级序复杂断块构造应力场定量模型与油气分布

The new theories include a tension stress theory of the rigid-plastic mechanical model when H/ D> 1 and a shearing stress theory of the hydrostatic stress mechanical model when H/ D < 1.

H/D

The result is coherent with the result of quantitative physical simulation, numerical value simulation and the tension stress theory of a rigid plastic mechanical model.

结果与定性物理模拟、数值模拟及刚塑性力学模型的拉应力理论相吻合。

Based on traditional structural vibration analysis, the effects of mean stress and its scatter have been introduced into the vibrational reliability model of structures by use of Goodman curve and the interference theory of stress and strength.

基于传统的结构振动分析，利用Goodman曲线和应力-强度干涉理论，将结构的平均应力及其分散性的影响引入结构振动可靠性模型。

In the upsetting technology theory, a tension stress theory of a rigid-plastic mechanical model and a shearing stress theory of a hydraulic stress mechanical model are proposed for upsetting a cylinder between flat platens, and a new type technology for upsetting between cone-platens is advanced.

在镦粗工艺理论方面，提出了圆柱体镦粗的刚塑性力学模型的拉应力理论和静水应力力学模型的切应力理论，设计了锥形板镦粗的新工艺。

The operation principle and structure features of a 220 kV cable terminal stress cone were simply described. The numerical simulation model of the cable terminal structure was proposed.

应用220kV电缆终端的结构型式和工作原理，建立了该种电缆终端结构的数值仿真模型；

Landslide is the scope of geomechanics, the establishment of an appropriate model of the mechanical structure, the theoretical stress and strain analysis.

滑坡属于地质力学的范畴，建立适当的力学结构模型，进行理论上的应力应变分析。

Research on tension stress theory of a rigid plastic mechanical model by optical plastics

用光塑法研究刚塑性力学模型拉应力理论

Based on the theory of stress wave, we define the model of loads, and we also educe the results that the torsional impact loads are the phase impact loads.

依据应力波传播理论定义载荷模型，得出圆柱壳扭转屈曲分析中瞬时冲击载荷为阶跃载荷的结论。

In addition, through the model experiment of pre-stressed rectangular square pyramid composite space truss, the correctness of characteristics of internal force and the feasibility of tension recovery method are proved.

另外，通过正放四角锥预应力组合网架的模型试验，验证了结构内力分布特点的正确性以及张力松弛法的可行性。

On basis of the actual transferring route of the stress flow inside pile caps measured in experiment and theory analysis, the transfer model of equilateral thick pile caps-'Dome Model with Tension Bar' is presented.

根据试验测得的传力路径和理论分析，提出了等边厚承台的传力模式&弯顶拉杆模型。

Based on the theory of Biot consolidation and visco elastic plasticity, the finite element model is constructed, and the corresponding finite element computer procedures are compiled at the same time, then the regularity of the stress and the strain of the sea embankment are analyzed.

本文首先基于弹塑性Biot固结理论，采用有限单元方法，编制了相应的有限元计算程序，对加固前后的海堤进行了应力应变分析。

The stress-strain state for notched specimens subjected to constant amplitude proportional multiaxial loadings was also calculated and analyzed by the finite element model and the theoretical stress concentration factor of the notched specimens had obtained.

针对多轴比例加载的情况，利用弹塑性有限元法对缺口件在拉&扭复杂加载下的应力应变场进行了计算和分析，得到了缺口件的应力集中系数。

The complete velocity model for plastic metal is structured with flow function. The boundary tear stress condition, which should be met by the velocity field of the Mises material plan or axisymmetrical deformation, is raised.

采用流函数法构造了塑性变形金属流动的完备速度模式，对Mises材料平面变形和轴对称变形问题，提出并推证了运动可能速度场应满足的力学边界条件一边界切应力约束方程。

Calculation Model and Experimental Verification on True Strain and True Stress in Hot Tensile Test

高温拉伸试验中真应力真应变的计算及试验研究

At the same time the paper establishes the solid finite element model of T-beam, and analyses the fatigue cracks, and the time-stress history of the reinforcement in tensile region and of the concrete in compressive zone under automobile load spectrum.

同时建立了T型梁有限元实体模型，分析了车辆荷载谱作用下梁的疲劳开裂、压区混凝土以及拉区钢筋的应力时间历程等问题。