熔化

The laser-TIG hybrid heating source heats the steel by a similar thermal conductivity welding way, and this will keep the melting metals of Mg, Ni, Fe a metastable state.

激光-TIG电弧复合热源在钢板上以类似于热导焊的焊接模式熔化母材，使得熔池中熔化的金属Mg、Ni以及Fe处于一种亚稳态。

Meanwhile, melt the white chocolate in a bowl suspended over simmering water.

同时，把碗置于微沸的水上，将白巧克力放入碗中使其熔化。

Metals will melt when heated to a certain temperature.

金属加热到一定的温度都会熔化.

It melts at very high temperature.

它在高温中熔化.

It is shown that the glass-melting temperature, the homogenizing time, and the water content in the environment during the glass-melting and the fiber-drawing process are very important technological parameters in order to reduce the scattering loss.

结果表明，选择适当的熔化温度和均化时间，玻璃熔化和光纤拉制时环境中低的水含量是制得的损耗氟锆酸盐玻璃光纤的关键；

A main thermal absorption peak for melting at 510 ℃ with its beginning temperature 450 ℃ was revealed using DSC instrument.

已用DSC分析该玻璃焊料，显示在510℃出现主晶相的熔化吸热峰，其开始熔化温度为445℃。

I smelled tarry melted asphalt.

我闻到了柏油熔化了的味道。

Take a sheet of filo pastry and brush it with melted butter.

取一张擀得很薄的油酥面皮，上面刷上一层熔化的牛油。

Together with extract useful information from the experimental data of molten salt phase diagrams.

用人工神经网络方法研究熔盐相图中间相的组成、熔点和同分熔化或异分熔化等规律.

Break up the chocolate and melt it.

把巧克力弄碎，使其熔化。

GLASOFENBAU LEIPZIG GMBH GlassGlassand Glass melting plants as well as Enamel plants and Glass melting furnaces.

GLASOFENBAUleipzigGMBH是一家高别级的产品供应商,该企业使用多种工艺制造玻璃熔化设备,熔化设备.

The wax from the two candles fused as they burned.

两根蜡烛上的蜡燃烧时熔化在一起.

The experimental results show that the double-peaks in DSC plots are owing to mutiple-melting behavior but not to polymorphy in PBT crystals.

结果表明：PBT结晶熔化时的DSC双峰图为多重熔化行为而非多晶型的结果；

This workshop melts down the metal scrap.

这个车间熔化废金属.

Test and analysis have been taken in view of crack appearance regularly of de-vitrified glass, It points out the crack is effected on lumpiness of recovery cullet, melting rate of furnace, heat treatment technology etc.

针对微晶玻璃炸裂出现的现象与规律，进行了试验与分析，指出回头碎玻璃的块度、熔化窑的熔化率、热处理工艺等对炸裂的影响；

The experimental object is separated by vacuum bottle and mixture of ice and water, for decreasing the heat exchange of ice from environment. The volume variety of ice during melt process is measured by the move-liquid tube, and the melting heat of ice is also measured.

真空保温杯和冰水混合物双重隔离实验对象，降低了冰与环境的热交换，通过移液管测量冰熔化成水的体积变化，进而测定冰的熔化热。

Melted wax dribbled down the side of the candle.

熔化了的蜡一滴滴从蜡烛边上流下。

Predictive model for local core melting accident caused by subassembly blockage in a fast reactor Analysis and Prevention to the Melt Down of Convection Bank in a Package Boiler

快堆局部堵流所致堆芯局部熔化事故的预测模型快装锅炉对流管束熔化事故原因分析及预防措施

Molten metal ran out on to the flagstones.

熔化的金属溢流到外面的板石上.

The partial melting process during increasing temperature includes uniformization of the compositions, divorced eutectic melting, and the partial melting and glomeration of primary α-Mg.

提出半固态熔化过程可分为成分均匀化、共晶熔化及部分初生相的熔化和球化完成3个阶段，不同熔化阶段的控制性因素不同。

The chocolate is then melted down to exactly the right temperature.

然后巧克力被熔化到了恰好的温度。

The metal will fuse at a relatively low temperature.

这金属在不太高的温度下熔化.

According to different ratio of raw materials for the refining of molten slag and steel temperature measurement balance test, analyzed and discussed refining slag basicity and components of the refining slag and steel melting temperature of inclusions morphology in the same Si 、 Mn deoxidization conditions.

按不同的原料配比进行了精炼渣的熔化温度测定和钢渣平衡试验，在相同的Si、Mn脱氧条件下，分析讨论了精炼渣碱度和组分对精炼渣熔化温度和钢中夹杂物形态的影响。

Igneous Rock , rock formed when molten or partially molten material, called magma, cools and solidifies.

火成岩是熔化或部分熔化的物质(岩浆)经过冷却固化形成.

The first is defined as melt-solution-precipitation mechanism; Ti powder in the combustion front is molten at high combustion temperature, W and C are dissolved into liquid Ti, Ti-W-C melt is formed and ( Ti, W) C is precipitated from the Ti-W-C melt.

熔化-溶解-析出机制：燃烧高温使燃烧前沿Ti粉熔化，W、C溶解于熔融Ti中，而后（Ti，W）C从Ti-W-C熔体中析出。

To liquefy or reduce to a plastic state by heating; melt.

熔化通过加热变成液体或可塑状态; 熔化.

Heat will melt iron.

热将使铁熔化.

Practice shows that measurement accuracy of the method is high, error of melting temperature is ± 1 ℃, and time accuracy of melting velocity is 0.1 ms.

生产实践表明：该方法测量精度高，熔化温度误差达±0.1℃，熔化速度时间精度达0.1ms。

Tin is a comparatively easy metal to smelt.

锡是比较容易熔化的金属.

In a large microwave-proof dish, melt butter for 20 seconds.

让黄油在微波适用的大盘子里熔化20秒钟。